Related Experiment Video
Updated: Aug 7, 2026

Stress Distribution During Cold Compression of Rocks and Mineral Aggregates Using Synchrotron-based X-Ray Diffraction
Published on: May 20, 2018
Relative and absolute density of reinforcement as factors influencing the peak shift
Abstract:
Four groups of six pigeons each were given nondifferential training on multiple variable-interval variable-interval reinforcement schedules and then were switched to differential training involving a multiple schedule in which reinforcement density was reduced in one of the two components. The multiple schedules used in the four groups had mean interreinforcement intervals of 1 min and 1 min in the two components changed to 1 min, 5 min; 2.5 min, 2.5 min changed to 2.5 min, 5 min; 12 sec, 12 sec changed to 12 sec, 24 sec; and 12 sec, 12 sec changed to 12 sec, 60 sec. In subsequently administered wavelength generalization tests, some peak shifts were observed in each condition and occurred occasionally in the absence of behavioral contrast or rate reduction in the less-reinforced component. The best predictor of peak shift was a high proportion of total responses emitted during the more-reinforced component at the end of differential training.
Related Concept Videos
Factors Affecting Creep
Further, the water/cement ratio is critical, as a lower ratio increases concrete strength, thus reducing creep. The strength of the...
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Relation Between the Distributed Load and Shear
Creep in Concrete
Effects of Creep
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...