Related Experiment Video
Updated: Aug 7, 2026

Enhanced Oil Recovery using a Combination of Biosurfactants
Published on: June 3, 2022
Keratin-rhamnolipids and keratin-sodium dodecyl sulfate interactions at the air/water interface
1Department of Chemical Engineering, Ege University, 35100 Izmir, Turkey. gunseli.ozdemir@ege.edu.tr
Abstract:
Keratin-surfactant interactions at the air/solution interface may be indicative for skin irritation by surfactants. In this study pure keratin was extracted from chicken feathers as described by Schrooyen at al. and the adsorption properties of biologically produced rhamnolipids (RL) and sodium dodecyl sulfate (SDS) mixed with keratin molecules were investigated by surface tension measurements. Keratin was added in three specific amounts to RL and SDS aqueous solutions of varying concentrations, respectively, and keratin-RL and keratin-SDS interactions were investigated at pH 6.2 and 5.0. The surface tension measurements showed that surfactant-keratin complexes were formed in the solutions at pH 6.2. At low RL concentrations the added amount of keratin decreased the surface tension as a result of the hydrophobic keratin-RL complexes formed, which have covered the air/solution interface. Beginning from moderate RL concentrations, less surface active keratin-RL complexes were formed due to hydrophilization of the former complexes and they were removed from the interface to the bulk phase as a result of the competitive adsorption mechanism and pure RL molecules covered the interface gradually. At low SDS concentrations surface tension decrease was also observed by the covering of the air/solution interface with keratin-SDS complexes. At moderate SDS concentrations the keratin-SDS complexes exhibited a more surface active feature. Unlike the keratin-RL complexes, they have remained at the interface until the higher SDS concentrations and keratin ratios. However, at the minimum surface tension value of the pure SDS at its CMC value, the surface tension of the keratin-SDS mixture reached the value of pure SDS solution and the air/solution interface has been covered again only with pure SDS monomers. The keratin-surfactant solutions prepared at pH 5 showed lower surface tension values compared to that measured at pH 6.2 and the surface tension behavior of RL and SDS resembled each other. Above a certain surfactant concentration the addition of keratin to surfactant solutions rendered the surface less surface active compared to their pure surfactant solutions at pH 5.0. The consideration of the surface tension behavior of two anionic surfactants has shown that the RL-keratin interactions are milder than SDS-keratin interactions at pH 6.2 and 5.0.
Related Concept Videos
Surface Active Agents
Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules, atoms, and/or ions)...
Micelles
Colloids
Intermolecular Forces in Solutions
When the strengths of the intermolecular forces of attraction between solute and solvent species in a solution are no different than those present in the separated components, the solution is formed with no accompanying energy change. Such a solution is called an ideal solution. A mixture of ideal gases (or gases such as helium and argon,...
Aqueous Solutions and Heats of Hydration
When ionic compounds dissolve in water, the ions in the solid separate and disperse uniformly throughout the solution because water molecules surround and solvate the ions, reducing the strong electrostatic forces between them. This process...

