Related Experiment Video
Updated: Feb 11, 2026

DNA Staining Method Based on Formazan Precipitation Induced by Blue Light Exposure
Published on: January 28, 2018
Strong green emission from alpha-SiAlON activated by divalent ytterbium under blue light irradiation
R-J Xie1, N Hirosaki, M Mitomo
1Advanced Materials Laboratory, National Institute for Materials Science (NIMS), Namiki 1-1, Tsukuba, Ibaraki 305-0044, Japan. Xie.Rong-Jun@nims.gp.jp
Abstract:
This contribution reports on luminescence properties of divalent ytterbium in alpha-SiAlON at room temperature. Ytterbium-doped alpha-SiAlON powders, with the compositions of (M(1-2x/v)Yb(x))(m/v)Si(12-m-n)Al(m+n)O(n)N(16-n) (M = Ca, Li, Mg, and Y, v is the valency of M, 0.002 < or = x < or = 0.10, 0.5 < or = m = 2n < or = 3.5), were synthesized by sintering at 1700 degrees C for 2 h under 0.5 MPa N2. A single, intense, broad emission band, centered at 549 nm, is observed due to the electronic transitions from the excited state 4f(13)5d to the ground state 4f14 of Yb2+. The luminescence of Yb2+ in alpha-SiAlON occurs at relatively low energy, which is attributable to the large crystal field splitting and nephelauxetic effect due to the nitrogen-rich coordination of Yb2+. The dependence of luminescence properties on the Yb2+ concentration, chemical composition, and annealing is discussed. It is suggested that this novel green phosphor could be applied in white light-emitting diodes (LEDs) when combined with a red phosphor and a blue LED.
More Related Videos
09:29In Vivo Investigation of Antimicrobial Blue Light Therapy for Multidrug-resistant Acinetobacter baumannii Burn Infections Using Bioluminescence Imaging
Published on: April 28, 2017
11:55In Vitro Reconstitution of Light-harvesting Complexes of Plants and Green Algae
Published on: October 10, 2014
Related Concept Videos
Green Algae
Titration Calculations: Strong Acid - Strong Base
A titration is carried out for 25.00 mL of 0.100 M HCl (strong acid) with 0.100 M of a strong base NaOH. The pH at different volumes of added base solution can be calculated as follows:
(a) Titrant volume = 0 mL. The solution pH is due to the acid ionization of HCl. Because this is a strong acid, the ionization is complete and the hydronium ion molarity is 0.100 M. The pH of the solution is then:
Emission Spectra
Strong Acid and Base Solutions
Titration of a Strong Acid with a Strong Base
Light as Energy
Photons
A photon is a discrete electromagnetic particle or bundle of energy. Photons are characterized by their frequency, wavelength, and amplitude, similar to the properties of a wave. Waves with higher frequencies transmit more energy and have shorter wavelengths than longer wavelengths that transmit...