Density functional theory study of pyrrole adsorption on Mo(110)

The objective of the present study is to identify possible adsorption configurations of pyrrole on Mo(110) using density functional theory (DFT) calculations. Several adsorption configurations were studied including pyrrole and pyrrolyl adsorption as parallel, perpendicular, and tilted adsorption modes relative to the Mo(110) surface plane. Based on the DFT calculations, pyrrole is suggested to adsorb in a parallel mode with respect to the Mo(110) surface through its pi-orbital as mu3,eta(5)-Pyr-0 degrees with an adsorption energy of -28.7 to -31.5 kcal mol(-1). The possibility of a coexisting mode where pyrrole adsorbs on the surface with a slightly tilted molecular plane as mu3,eta(4)(N,C2,C3,C4)-Pyr-5 degrees is also likely to occur, particularly at higher pyrrole coverages. The slightly tilted configuration is suggested to arise from the lateral interactions of adsorbed pyrrole on Mo(110), and not the result of a phase transformation on the surface since this requires a relatively high activation energy as indicated by additional linear synchronous transit (LST)/quadratic synchronous transit (QST) calculations. Both adsorption geometries bond to three surface Mo atoms, and Mo(110) did not promote hydrogen abstraction. Pyrrolyl adsorption on Mo(110) is energetically possible, but unlikely to occur because gas-phase hydrogen has not been previously experimentally observed as a pyrrole decomposition product on Mo(110).