Influence of synthesis methods on tungsten dispersion, structural deformation, and surface acidity in binary WO3-ZrO2...

WO3-ZrO2 catalysts were synthesized by precipitating the aqueous solutions of zirconium oxynitrate and ammonium metatungstate with ammonium hydroxide. The white slurry precipitate was treated under three different conditions. In the as-made materials, the amorphous phase was formed in the aged and refluxed samples, while well-crystallized tetragonal and monoclinic phases were obtained in the hydrothermally treated sample. The real amount of tungsten loaded in the samples was similar for the three samples, independently of the treatments; however, the tungsten surface atomic density in the annealed WO3-ZrO2 samples varied between 6 and 9 W atoms/nm2. Two different contrast types of aggregates were determined by scanning electron microscopy, the white particles which are rich in W, and the gray ones which are rich in zirconium; both of them were formed in the calcined solids prepared under aging or reflux condition. A very high dispersion of tungsten species on the zirconia surface was achieved in the hydrothermally treated sample. The degree of the interaction between WO(x) and ZrO2 surface strongly modified the Zr-O bond lengths and bond angles in the structure of tetragonal zirconia as proved by X-ray diffraction analysis and the Rietveld refinement. The catalyst obtained under hydrothermal condition exhibited the highest dispersion of tungsten species in the zirconia, which in turn causes strong structural deformation of the tetragonal ZrO2 phase responsible of the strongest surface acidity and, consequently, the optimum catalytic activity for n-hexane isomerization.