The effect of temperature on viscoelastic properties of glass ionomer cements and compomers

The objective of this study was to determine the viscoelastic properties of different types of glass ionomer cements (GICs) and compomers under varying temperature conditions found in the mouth. The materials tested were a conventional GIC (Aqua Ionofil U), a resin modified GIC (Fuji II LC), a highly viscous GIC (Voco Ionofil Molar), and two polyacid modified composite resins/compomers (Glasiosite and Dyract Flow). Six groups of four specimens were prepared from each material. One group was stored dry for 24 h and was subsequently tested dry at 21 degrees C. Each of the remaining five groups was stored for 24 h in distilled water at the temperatures 21, 30.5, 37, 43.5, and 50 degrees C, respectively, and was subsequently tested at that temperature. Shear storage modulus and loss tangent were determined by conducting dynamic torsional loading. Static shear moduli were determined by applying a constant torque (below the proportional limit of the materials) for 10 s and recording the angular deformation of the specimens. Data were analyzed by ANOVA and Duncan's test (alpha= 0.05). It was found that the viscoelastic properties varied significantly (p < 0.05) across the different materials. The compomer Glasiosite, with the highest filler content, and the highly viscous GIC Voco Ionofil Molar exhibited the highest elastic moduli and lowest loss tangents. Viscoelastic properties varied also significantly (p < 0.05) with temperature levels, but changes in the tested region were not indicative of a glass transition. Dynamic shear storage moduli were highly correlated to the static ones. Storage in water lowered the values of elastic moduli.