Resin bonding to dentin irradiated by high repetition rate Er:YAG laser

This study evaluated the influence of laser irradiation with a high pulse repetition rate on dentin bonding.

Although resin bonding to erbium:yttrium-aluminium-garnet (Er:YAG) laserirradiated dentin has frequently been investigated, the effects of a high pulse repetition rate have not yet been sufficiently investigated.

Four groups treated under different laser conditions were evaluated in this study: 100 mJ/pulse-10 pulses per second [pps], 50 mJ/pulse-20 pps, 33 mJ/pulse-30 pps, and the unlased condition as a control. The total energy used to irradiate each group was adjusted to 1.0 W. After bovine dentin specimens were irradiated by an Er:YAG laser, acid conditioners (10% citric acid/3% ferric chloride) were applied to the lased surface. Thereafter, a PMMA rod was bonded to the lased dentin using 4- META/MMA-TBB resin, and mini-dumbbell-shaped specimens were prepared. These specimens were then tested under tensile mode and fractured surfaces were observed under scanning electron microscopy (SEM).

The bond strength of the unlased control was significantly higher than those of the three lased groups. Among the three lased groups, irradiation with higher output energy and lower pulse repetition rate tended to affect the higher bond strength. Upon SEM observation of the fractured surface, the lased groups showed the mixture of failure in the hybrid layer in almost part. There was no significant difference among the three lased groups.

It can be concluded from the results of this study that a higher pulse repetition rate is not effective for resin bonding to laser-irradiated dentin.