Related Experiment Video

Updated: Aug 6, 2026

Age-dependent Dynamics of Locomotion in Caenorhabditis elegans: A Lyapunov Exponent Analysis
06:44

Age-dependent Dynamics of Locomotion in Caenorhabditis elegans: A Lyapunov Exponent Analysis

Published on: September 23, 2025

Linear response to perturbation of nonexponential renewal process: A generalized master equation approach

I M Sokolov1

  • 1Institut für Physik, Humboldt-Universität zu Berlin, Newtonstrasse 15, D-12489 Berlin, Germany.

Physical Review. E, Statistical, Nonlinear, and Soft Matter Physics
|August 16, 2006
PubMed

More Related Videos

Continuous Measurement of Biological Noise in Escherichia Coli Using Time-lapse Microscopy08:25

Continuous Measurement of Biological Noise in Escherichia Coli Using Time-lapse Microscopy

Published on: April 27, 2021

An Analog Macroscopic Technique for Studying Molecular Hydrodynamic Processes in Dense Gases and Liquids11:03

An Analog Macroscopic Technique for Studying Molecular Hydrodynamic Processes in Dense Gases and Liquids

Published on: December 4, 2017

Related Concept Videos

Modeling with Differential Equations01:25

Modeling with Differential Equations

Population dynamics can be described mathematically by considering the population size P(t) as a function of time. The rate of change of the population is then represented by the derivative of P(t). A simple assumption is that the rate of growth is proportional to the size of the population itself. This leads to an exponential growth model, where the population increases rapidly without bound. While this is a useful first approximation, it does not reflect realistic long-term...
Exponential Equations for Modeling Growth01:26

Exponential Equations for Modeling Growth

Exponential models are essential for describing rapid, multiplicative changes in natural systems, such as population growth. When a population doubles at regular intervals, the process can be modeled using a suitable base. For instance, a bacterial culture that doubles every three hours follows the model n(t)=n0⋅2t/3, where n(t) is the population at the time t.A more general model uses the natural base e, especially for continuous growth. This takes the form n(t)=n0⋅ert, where r is the relative...
Types of Responses of Series RLC Circuits01:11

Types of Responses of Series RLC Circuits

A second-order differential equation characterizes a source-free series RLC circuit, marking its distinct mathematical representation. The complete solution of this equation is a blend of two unique solutions, each linked to the circuit's roots expressed in terms of the damping factor and resonant frequency.
Linear Approximation in Time Domain01:21

Linear Approximation in Time Domain

Nonlinear systems often require sophisticated approaches for accurate modeling and analysis, with state-space representation being particularly effective. This method is especially useful for systems where variables and parameters vary with time or operating conditions, such as in a simple pendulum or a translational mechanical system with nonlinear springs.
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length, the...
Introduction to Exponential Functions01:29

Introduction to Exponential Functions

Exponential functions are fundamental in modeling dynamic processes where the rate of change is proportional to the current value. Defined by f(x) = bx, where b is a positive constant not equal to one, they form the basis for describing processes of growth and decay depending on whether the base b is greater than or less than one.Exponential models describe situations where change occurs at a rate proportional to the current amount. These include phenomena such as bacterial proliferation,...
Second Order systems II01:18

Second Order systems II

In an underdamped second-order system, where the damping ratio ζ is between 0 and 1, a unit-step input results in a transfer function that, when transformed using the inverse Laplace method, reveals the output response. The output exhibits a damped sinusoidal oscillation, and the difference between the input and output is termed the error signal. This error signal also demonstrates damped oscillatory behavior. Eventually, as the system reaches a steady state, the error diminishes to zero.
If  ζ...