Related Experiment Video
Updated: Jul 20, 2026

Determining the Mechanical Strength of Ultra-Fine-Grained Metals
Published on: November 22, 2021
Strain-induced disorder, phase transformations, and transformation-induced plasticity in hexagonal boron nitride
Valery I Levitas1, Yanzhang Ma, Javad Hashemi
1Department of Mechanical Engineering, Texas Tech University, Lubbock, Texas 79409-1021, USA. valery.levitas@ttu.edu
Abstract:
Plastic shear significantly reduces the phase transformation (PT) pressure when compared to hydrostatic conditions. Here, a paradoxical result was obtained: PT of graphitelike hexagonal boron nitride (hBN) to superhard wurtzitic boron nitride under pressure and shear started at about the same pressure ( approximately 10 GPa) as under hydrostatic conditions. In situ x-ray diffraction measurement and modeling of the turbostratic stacking fault concentration (degree of disorder) and PT in hBN were performed. Under hydrostatic pressure, changes in the disorder were negligible. Under a complex compression and shear loading program, a strain-induced disorder was observed and quantitatively characterized. It is found that the strain-induced disorder suppresses PT which compensates the promotion effect of plastic shear. The existence of transformation-induced plasticity (TRIP) was also proved during strain-induced PT. The degree of disorder is proposed to be used as a physical measure of plastic straining. This allows us to quantitatively separate the conventional plasticity and transformation-induced plasticity. Surprisingly, it is found that TRIP exceeds the conventional plasticity by a factor of 20. The cascade structural changes were revealed, defined as the reoccurrence of interacting processes including PTs, disordering, conventional plasticity, and TRIP. In comparison with hydrostatic loading, for the same degree of disorder, plastic shear indeed reduces the PT pressure (by a factor of 3-4) while causing a complete irreversible PT. The analytical results based on coupled strain-controlled kinetic equations for disorder and PT confirm our conclusions.
Related Concept Videos
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Plastic Behavior
Transformation of Plane Stress
Transformation of Plane Strain
Under plane strain conditions, typical for members where one dimension significantly exceeds the others, deformations and resultant strains are...
Three-Dimensional Analysis of Strain
Plastic Deformation in Circular Shafts

