[Application of normoxic polymer gels in 3D-dosimetry for radiosurgery]

The aim of this study was to describe the manufacture of normoxic polymer gels, to characterize their dose response relationship, to optimize MR imaging parameters in order to minimize the standard deviation in the measured dose and to use the gel in a dose verification experiment in radiosurgery. The normoxic polymer gel used is simple to manufacture under normal atmospheric conditions and is characterized by a linear dose relationship up to 40 Gy. MR imaging was performed using 2-dimensional (20) single spin echo pulse sequences with two different echo times. The imaging parameters were optimized in order to minimize the standard deviation of the measured transversal relaxation rate R2 and to achieve a geometrical resolution of 1.5 mm. Comparisons of calculated and measured relative 3D dose distributions using a multi isocentric irradiation with Gamma Knife B showed a good overall agreement of both the isodose levels and the differential and cumulative dose volume histograms. The standard deviation in the measured dose was approximately 9% at 30 Gy. The evaluation according to the gamma criterion showed that 96% of the dose voxels remained within a spatial uncertainty of 1.5 mm and a dose uncertainty of 8%.