Spin labeling analysis of amyloids and other protein aggregates

Related Experiment Video

Updated: Feb 10, 2026

Methods to Study Changes in Inherent Protein Aggregation with Age in Caenorhabditis elegans
11:57

Methods to Study Changes in Inherent Protein Aggregation with Age in Caenorhabditis elegans

Published on: November 26, 2017

9.2K

Martin Margittai1, Ralf Langen

  • 1University of Southern California, Department of Biochemistry and Molecular Biology, Los Angeles, CA, USA.

Methods in Enzymology
|October 19, 2006
PubMed

More Related Videos

Purification and Aggregation of the Amyloid Precursor Protein Intracellular Domain10:08

Purification and Aggregation of the Amyloid Precursor Protein Intracellular Domain

Published on: August 28, 2012

12.3K
Screening for Amyloid Aggregation by Semi-Denaturing Detergent-Agarose Gel Electrophoresis10:03

Screening for Amyloid Aggregation by Semi-Denaturing Detergent-Agarose Gel Electrophoresis

Published on: July 16, 2008

28.5K

Related Concept Videos

Amyloid Fibrils03:03

Amyloid Fibrils

Amyloid fibrils are aggregates of misfolded proteins.  Under most circumstances, misfolded proteins are either refolded by chaperone proteins or degraded by the proteasome. However, in the case of a mutation or a disease, these proteins can accumulate to form large clusters and often further assemble to form elongated fibers, called fibrils. 
Amyloid deposits were observed as early as 1639 in the liver and the spleen.   In 1854, Rudolph Virchow performed iodine staining,...
12.0K
Amyloid Fibrils03:03

Amyloid Fibrils

No description available
6.5K
NMR Spectroscopy: Spin–Spin Coupling01:08

NMR Spectroscopy: Spin–Spin Coupling

The spin state of an NMR-active nucleus can have a slight effect on its immediate electronic environment. This effect propagates through the intervening bonds and affects the electronic environments of NMR-active nuclei up to three bonds away; occasionally, even farther. This phenomenon is called spin–spin coupling or J-coupling. Coupling interactions are mutual and result in small changes in the absorption frequencies of both nuclei involved. While nuclei of the same element are involved...
3.3K
Spin–Spin Coupling: One-Bond Coupling01:17

Spin–Spin Coupling: One-Bond Coupling

Coupling interactions are strongest between NMR-active nuclei bonded to each other, where spin information can be transmitted directly through the pair of bonding electrons. While nuclei polarize their electrons to the opposite spins, the bonding electron pair has opposite spins. Configurations with antiparallel nuclear spins are expected to be lower in energy. When coupling makes antiparallel states more favorable, J is considered to have a positive value. The one-bond coupling constant, 1J,...
1.5K
Spin–Spin Coupling Constant: Overview01:08

Spin–Spin Coupling Constant: Overview

In bromoethane, the three methyl protons are coupled to the two methylene protons that are three bonds away. In accordance with the n+1 rule, the signal from the methyl protons is split into three peaks with 1:2:1 relative intensities. The methylene protons appear as a quartet, with the relative intensities of 1:3:3:1.
Qualitatively, any spin plus-half nucleus polarizes the spins of its electrons to the minus-half state. Consequently, the paired electron in the hydrogen–carbon bond must...
1.5K
Spin–Spin Coupling: Two-Bond Coupling (Geminal Coupling)01:20

Spin–Spin Coupling: Two-Bond Coupling (Geminal Coupling)

Two NMR-active nuclei bonded to a central atom can be involved in geminal or two-bond coupling. Geminal coupling is commonly seen between diastereotopic protons in chiral molecules and unsymmetrical alkenes, among others.
The central atom need not be NMR-active because its electrons are affected by the electron polarization of the spin-active atoms. However, spin information is transmitted less effectively than in one-bond coupling, and 2J values are usually weaker than 1J values. The energy of...
1.7K