pi-Allylic C1-substitution in water with nitromethane using amphiphilic resin-supported palladium complexes

In organic synthesis, the formation of products can be altered by changing the reaction conditions. For example, a dibromo addition product is formed when propene is treated with bromine at room temperature. In contrast, propene undergoes allylic substitution in non-polar solvents at high temperatures to give 3-bromopropene. In order to avoid the addition reaction, the bromine concentration must be kept as low as possible throughout the reaction. This can be achieved using N-bromosuccinimide...

Nitriles are reduced to amines in the presence of strong reducing agents like lithium aluminum hydride through a typical nucleophilic acyl substitution. The reaction requires two equivalents of the reducing agent. The reducing agent acts as a source of hydride ions.
As shown below, the mechanism involves three steps. Firstly, the hydride ion acting as a nucleophile attacks the nitrile carbon to form an anion. In the second step, a second equivalent of the hydride ion attacks the anion to...

Introduction
Like alkenes, alkynes can be reduced to alkanes in the presence of transition metal catalysts such as Pt, Pd, or Ni. The reaction involves two sequential syn additions of hydrogen via a cis-alkene intermediate.

Direct alkylation is not a suitable method for synthesizing amines because it produces polyalkylated products. Gabriel synthesis is the most preferred method to exclusively make primary amines. The method uses phthalimide, which contains a protected form of nitrogen that participates in alkylation only once to predominantly give primary amines.
Strong bases like NaOH or KOH deprotonate the phthalimide to form the corresponding anion, which acts as a nucleophile. Further, the anion attacks an...

Catalytic hydrogenation of alkenes is a transition-metal catalyzed reduction of the double bond using molecular hydrogen to give alkanes. The mode of hydrogen addition follows syn stereochemistry.
The metal catalyst used can be either heterogeneous or homogeneous. When hydrogenation of an alkene generates a chiral center, a pair of enantiomeric products is expected to form. However, an enantiomeric excess of one of the products can be facilitated using an enantioselective reaction or an...

The rate of acid-catalyzed hydration of alkenes depends on the alkene's structure, as the presence of alkyl substituents at the double bond can significantly influence the rate.