Afterword--Loaded dice: multinational oil, workers, and the state

Distributed loads are a common type of load that engineers and scientists encounter in various practical situations. Distributed loads often refer to a type of load spread over a surface or a structure and can be modeled as continuous force per unit area.
For example, consider a bookshelf filled with books stacked vertically adjacent to each other. The weight of the books is evenly distributed over the length of the shelf. As a result, the pressure at different locations on the surface of the...

The total work done on an object acted upon by multiple forces can be computed using two methods that give the same result. In one method, the work done by each force is first calculated. Then, those values are summed algebraically to calculate the total work done by all the forces. In the second method, the net force is first calculated by a vector sum of all the forces. Then, the work done by this force is obtained.
Since forces perpendicular to the displacement do no work, they do not...

Solids, liquids, and gases are the three states of matter commonly found on Earth. A solid is rigid and possesses a definite shape. A liquid flows and takes the shape of its container, except it forms a flat or slightly curved upper surface when acted upon by gravity. Both liquid and solid samples have volumes nearly independent of pressure. A gas takes both the shape and volume of its container.
Scientists have discovered a fourth state of matter, plasma, that occurs naturally in the interiors...

Work and power in rotational motion are completely analogous to work and power in translational motion. The total work done to rotate a rigid body through an angle 'θ' about a fixed axis is the sum of the torques integrated over the angular displacement. Hence, torque and angular displacement in rotational motion are analogous to force and linear displacement in translational motion, respectively.
Similarly, the power delivered to a system that is rotating about a fixed axis is given by the...

Thin-walled members with non-symmetrical cross-sections are vital to engineering structures, offering material efficiency and structural integrity. However, unsymmetrical loading on these members leads to complex stress distributions, resulting in simultaneous bending and twisting can cause deformation or structural failure. The interaction between bending and twisting requires detailed analysis to ensure structural resilience.
The concept of the shear center is crucial in countering the...

Changes in the environment of the early Earth drove the evolution of organisms. As prokaryotic organisms in the oceans began to photosynthesize, they produced oxygen. Eventually, oxygen saturated the oceans and entered the air, resulting in an increase in atmospheric oxygen concentration, known as the oxygen revolution approximately 2.3 billion years ago. Therefore, organisms that could use oxygen for cellular respiration had an advantage. More than 1.5 years ago, eukaryotic cells and...