Related Experiment Videos

T-S region-based fuzzy control with multiple performance constraints

Sheng-Ming Wu1, Chein-Chung Sun, Wen-Jer Chang

  • 1Department of Electrical Engineering, National Central University, Chung-li 320, Taiwan, ROC.

ISA Transactions
|January 30, 2007
PubMed

Related Concept Videos

Controller Configurations01:22

Controller Configurations

Controller configurations are crucial in a car's cruise control system because they manage speed over time to maintain a consistent pace regardless of road conditions, thereby meeting design goals. In traditional control systems, fixed-configuration design involves predetermined controller placement. System performance modifications are known as compensation.
Control-system compensation involves various configurations, most commonly series or cascade compensation, in which the controller aligns...
Lagrange Multipliers: Two Constraints01:28

Lagrange Multipliers: Two Constraints

The method of Lagrange multipliers with two constraints is used to optimize a function subject to two independent constraints. In many applications, the objective function represents a quantity to be maximized or minimized, such as cost, area, distance, or energy. The two constraints represent requirements that the solution must satisfy, such as fixed volume, limited resources, or prescribed dimensions.For a function of three variables, each constraint forms a surface in three-dimensional space.
Lagrange Multipliers: One Constraint01:29

Lagrange Multipliers: One Constraint

In constrained optimization, the objective is to maximize or minimize a quantity while satisfying a fixed condition. A standard example is a rectangular pen built against a barn wall using 100 meters of fencing. Because the wall provides one side of the enclosure, only the other three sides require fencing. The problem is to find the dimensions that produce the greatest possible area.Let L represent the length parallel to the wall and W the width perpendicular to it. The area of the pen is A =...
Lagrange Multipliers: Problem Solving01:30

Lagrange Multipliers: Problem Solving

A silo with a cylindrical base, flat bottom, and hemispherical roof is a common design in agricultural and industrial storage due to its structural efficiency and ease of construction. Optimizing its dimensions to maximize storage capacity for a given amount of material—i.e., a fixed surface area—is a classic problem in applied calculus and engineering design. The key parameters are the radius r of the base and the height h of the cylindrical section.The total volume of the silo is obtained by...
Feedback control systems01:26

Feedback control systems

Feedback control systems are categorized in various ways based on their design, analysis, and signal types.
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Region of Convergence of Laplace Tarnsform01:20

Region of Convergence of Laplace Tarnsform

The Region of Convergence (ROC) is a fundamental concept in signal processing and system analysis, particularly associated with the Laplace transform. The ROC represents an area in the complex plane where the Laplace transform of a given signal converges, determining the transform's applicability and utility.
Consider a decaying exponential signal that begins at a specific time. When deriving its Laplace transform, the time-domain variable is replaced with a complex variable. This substitution...