Nanomechanical properties of globular proteins: lactate oxidase

We report on the study of the nanomechanical properties of a lactate oxidase (LOx) monolayer immobilized on gold substrates by atomic force microscopy techniques operating under buffer conditions. Topographical contact mode imaging evidenced the protein deformation under the applied tip load. We performed approaching force curves with both stiff and soft cantilevers by imposing maximum loads of 1.6 nN and 400 pN, respectively. We found that the experimental data were well fitted by the Hertz model for a conical indenter. The use of two types of cantilevers allowed us to check further the consistency of the applicability of the Hertz model to the experimental data. After analyzing 180 curves, we obtained an average value of Young's modulus for the LOx layer in the 0.5-0.8 GPa range. These results agreed with those obtained for LOx submonolayer deposits on mica substrates, which allows discarding any important contribution from the underlying substrate on the measured properties. This range of values is closer to those obtained by other techniques on other globular proteins in comparison with those reported in previous AFM studies on similar systems. We found that for our experimental conditions the force curves can be, in principle, well fitted by the Hertz model for both conical and spherical indenter geometries. However, as the Young's modulus obtained for both geometries can differ appreciably, it becomes necessary to assess which indenter geometry is more adequate to explain the experimental data. For such purpose a systematic study of the indentation versus applied force curves obtained from both fittings for all the experimental curves was done.