Related Experiment Video
Updated: Jul 17, 2026
Imaging of the Microstructural Failure Mechanism in the Human Hip
Published on: September 29, 2023
Tibial geometry is associated with failure load ex vivo: a MRI, pQCT and DXA study
D Liu1, S L Manske, S A Kontulainen
1Department of Orthopaedics, University of British Columbia, Vancouver, Canada.
Unlabelled:
We studied the relations between bone geometry and density and the mechanical properties of human cadaveric tibiae. Bone geometry, assessed by MRI and pQCT, and bone density, assessed by DXA, were significantly associated with bone's mechanical properties. However, cortical density assessed by pQCT was not associated with mechanical properties.
Introduction:
The primary objective of this study was to determine the contribution of cross-sectional geometry (by MRI and pQCT) and density (by pQCT and DXA) to mechanical properties of the human cadaveric tibia.
Methods:
We assessed 20 human cadaveric tibiae. Bone cross-sectional geometry variables (total area, cortical area, and section modulus) were measured with MRI and pQCT. Cortical density and areal BMD were measured with pQCT and DXA, respectively. The specimens were tested to failure in a four-point bending apparatus. Coefficients of determination between imaging variables of interest and mechanical properties were determined.
Results:
Cross-sectional geometry measurements from MRI and pQCT were strongly correlated with bone mechanical properties (r(2) range from 0.55 to 0.85). Bone cross-sectional geometry measured by MRI explained a proportion of variance in mechanical properties similar to that explained by pQCT bone cross-sectional geometry measurements and DXA measurements.
Conclusions:
We found that there was a close association between geometry and mechanical properties regardless of the imaging modality (MRI or pQCT) used.
