Residual force depression is not abolished following a quick shortening step

W Herzog1, T R Leonard

  • 1University of Calgary, 2500 University Dr. N.W. Calgary, Canada. walter@kin.ucalgary.ca

Journal of Biomechanics
|February 28, 2007
PubMed

Related Concept Videos

Residual Stresses01:26

Residual Stresses

Residual stresses reside in a structure even after removing the original stress inducer. This phenomenon often arises from varied plastic deformations across different parts of a structure. Consider a rod stretched beyond its yield point. It will not regain its original length due to permanent deformation. Even after load removal, the rod does not entirely lose stress because of uneven plastic deformations, resulting in residual stresses. The computation of these stresses in structures is...
Residual Stresses in Circular Shafts01:10

Residual Stresses in Circular Shafts

In materials that exhibit elastic and plastic behavior, known as elastoplastic materials, residual stresses can accumulate when these materials experience plastic deformation. This deformation arises from either high levels of shearing stress or significant strains. Residual stresses are internal stresses that persist within a material after removing the external force causing deformation. This phenomenon is demonstrated when observing the behavior of a shaft under torque; notably, the shaft's...
Static Friction01:18

Static Friction

Static friction is a force that opposes the relative motion or tendency of motion between two surfaces in contact. It plays a crucial role in our daily lives, from walking on the ground to driving a car.
For example, consider a scenario where a truck is connected to a car by a rope, ready to tow it along a road. When no external force is applied by the truck, the car remains stationary and is said to be in static equilibrium. In this case, the forces acting on the car, such as gravity and the...
Residual Stresses in Bending01:18

Residual Stresses in Bending

In the study of elastoplastic members subjected to bending moments, understanding the loading and unloading phases is crucial for assessing material behavior and structural integrity. During the loading phase, as the bending moment increases, the material initially responds elastically, adhering to Hooke's Law, where stress is directly proportional to strain. When the load exceeds the yield strength, plastic deformation occurs, resulting in permanent strain and deformation that remains even...
Upward Impending Motion01:21

Upward Impending Motion

A square-threaded screw jack is a mechanical device widely used for lifting heavy loads or applying considerable force. Its operation is based on converting the force applied at its handle into a torsional moment, causing the upward impending motion of the screw. This movement is accomplished by overcoming the static friction between the threads of the screw and the jack.
To better comprehend how a screw jack functions, consider the completely unraveled thread as a block in contact with the...
Static and Kinetic Frictional Force01:05

Static and Kinetic Frictional Force

One of the simpler characteristics of sliding friction is that it is parallel to the contact surfaces between systems, and is always in a direction that opposes the motion or attempted motion of the systems relative to each other. If two systems are in contact and moving relative to one another, then the friction between them is called kinetic friction. For example, kinetic friction slows a hockey puck sliding on ice.
However, if two systems are in contact and are stationary relative to one...