Related Experiment Video
Updated: Jul 16, 2026

Visualization of Low-Level Gamma Radiation Sources Using a Low-Cost, High-Sensitivity, Omnidirectional Compton Camera
Published on: January 30, 2020
Experimental investigation of gamma-ray attenuation in Jordanian building materials using HPGe-spectrometer
Mohammad I Awadallah1, Mousa M A Imran
1Radiation Measurements Laboratory, Faculty of Applied Science, Al-Balqa Applied University, Al-Salt 19117, Jordan. awadkt@gmail.com
Abstract:
The capabilities of some building materials used in Jordan to attenuate gamma radiation were tested. Measurements of the attenuation coefficients of limestone, bricks and concrete have been carried out using a HPGe-spectrometer. Narrow beam technique was used, with a multiple gamma radiation source of different energy lines. Results indicate that variations in the attenuation coefficient for all limestone samples, at the same energy line, are within the experimental uncertainties. On the basis of the results achieved, an empirical formula mu(m)=AE(-0.44) was proposed to calculate attenuation at various incident energies. Limestone of average thickness 7cm was found to stop 75% of a gamma beam of energy 662keV. Meanwhile a brick of effective thickness 7cm was found to stop 60% of the same beam. The total attenuation coefficient of concrete calculated at 1333keV was 11.2m(-1), which is less than that of limestone and bricks.
More Related Videos
Related Concept Videos
Atomic Absorption Spectroscopy: Radiation and Light Sources
Two common narrow-range 'line' sources used in AAS are hollow-cathode lamps (HCLs) and...
Atomic Absorption Spectroscopy: Lab
Solutions containing organic solvents, such as low-molecular-mass alcohols, esters, or ketones, enhance absorbances by increasing nebulizer...
Gas Chromatography: Types of Detectors-II
Atomic Absorption Spectroscopy: Instrumentation
The atomizer used in AAS can be either a flame atomizer or an...
Atomic Emission Spectroscopy: Lab
Atomic Absorption Spectroscopy: Interference
Spectral interference occurs when signals from other elements or molecules overlap with the analyte signal, falsely elevating or masking the analyte's absorbance. This interference can be corrected using Zeeman,...

