Related Experiment Video

Updated: Jul 16, 2026

Granulocyte-dependent Autoantibody-induced Skin Blistering
12:23

Granulocyte-dependent Autoantibody-induced Skin Blistering

Published on: October 12, 2012

High concentration formulation feasibility of human immunoglubulin G for subcutaneous administration

Bhas Dani1, Robert Platz, Stelios T Tzannis

  • 1Nektar Therapeutics, 150 Industrial Road, San Carlos, California 94070, USA.

Journal of Pharmaceutical Sciences
|March 28, 2007
PubMed

The delivery of monoclonal antibodies (mAbs) as subcutaneous (sc) injections hinges on the high dose requirement of these usually low potency molecules. This necessitates their formulation as high concentration solutions or suspensions, which presents a formidable formulation challenge due to the concentration-driven protein aggregation and high solution viscosity generated at these conditions. The objective of this study was to evaluate the feasibility of spray-drying in preparing stable, high concentration formulations of mAbs. A model polyclonal antibody, human immunoglobulin G (IgG) was formulated as dry powder using Nektar's glass stabilization technology. Formulation in sugar glasses stabilized IgG during spray-drying and maintained the protein's secondary structure. Further, in contrast to the bulk material, the glass-stabilized powders successfully reconstituted at 200 mg/mL IgG without loss of the protein monomer. Spectroscopic analysis confirmed that upon high concentration reconstitution, spray-dried glass-stabilized IgG retained both its secondary and tertiary structure. Further, the spray-dried powder reconstituted within a few minutes yielding clear, low viscosity solutions that syringed easily through narrow (28 G) needles. The results of this study suggest that formulation in spray-dried, glass-stabilized powders may enable the development of products suitable for sc administration of mAbs and other low potency protein therapeutics.

More Related Videos

High Yield Expression of Recombinant Human Proteins with the Transient Transfection of HEK293 Cells in Suspension11:42

High Yield Expression of Recombinant Human Proteins with the Transient Transfection of HEK293 Cells in Suspension

Published on: December 28, 2015

Related Concept Videos

Production of Pharmaceuticals01:30

Production of Pharmaceuticals

Industrial insulin production uses genetically engineered E. coli expressing a proinsulin gene controlled by a tryptophan promoter and containing a methionine linker for later cleavage. The cells also carry ampicillin resistance for selective growth. Seed cultures are stored at −80 °C and production begins by thawing a small amount to inoculate starter cultures, which are progressively scaled to a 50,000-L bioreactor. In the bioreactor, E. coli grow in nutrient-rich media under sterile, tightly...
Insulin Formulations: Types and Delivery01:27

Insulin Formulations: Types and Delivery

Insulin preparations are categorized by their duration of action into short-acting and long-acting types. Two strategies are used to modify insulin's absorption and pharmacokinetic profile: slowing the absorption post-subcutaneous injection, or altering human insulin's amino acid sequence or protein structure. These changes retain the insulin's ability to bind to the insulin receptor, but alter its behavior in solution or after injection.
Short-acting insulins are divided into rapid-acting...
Routes of Drug Administration: Parenteral01:25

Routes of Drug Administration: Parenteral

The administration of drugs via parenteral routes allows for direct drug introduction into the systemic circulation, resulting in high bioavailability because the medication bypasses the harsh conditions of the gastrointestinal tract and hepatic metabolism.
The intravenous route (IV) of drug administration can be further categorized into two types. The bolus injection administers the entire dose rapidly, while an intravenous infusion slowly delivers smaller doses steadily.
The IV route is often...