The perpendicular-axis theorem states that the moment of inertia of a planar object about an axis perpendicular to its plane is equal to the sum of the moments of inertia about two mutually perpendicular concurrent axes lying in the plane of the body.
Consider a circular disc of mass M and radius R lying along an x-y plane. The origin lies at the center of the disc, and the z-axis is perpendicular to the disc's plane. All three axes coincide at the disc's center. The moment of inertia of this...

Mohr's circle is a crucial graphical method used to analyze plane strain by plotting strain on a set of cartesian coordinates, where the abscissa is normal strain ∈ and the ordinate is shear strain γ. Similarly to Mohr’s circle for plane stress, two points X and Y are plotted. Their coordinates are (∈x, -γXY) and (∈Y, γXY), respectively.
Mohr's circle visually represents the strain states under various conditions, which is essential for understanding material behavior. The center of Mohr's...

Collar bearings are essential in various machines designed to support axial loads on rotating shafts. Depending on the specific application and requirements, they can be found with single or multiple collars.

Curvature describes how rapidly a curve changes direction at a particular point. A curve with a small curvature bends gently, while a curve with a large curvature turns sharply. For a space curve, the position of a moving object can be described by a vector-valued function r(t), where t often represents time. The direction of motion is determined by the tangent vector, and the unit tangent vector is obtained by normalizing the derivative of the position vector.The unit tangent vector gives the...

Norton's theorem is a fundamental principle stating that a linear two-terminal circuit can be substituted with an equivalent circuit, which comprises a current source (ⅠN) in parallel with a resistor (RN). Here, ⅠN represents the short-circuit current flowing through the terminals, and RN stands for the input or equivalent resistance at the terminals when all independent sources are deactivated. This implies that the circuit illustrated in Figure (a) can be exchanged with the one depicted in...

The method of joints is a commonly used technique to analyze the forces in structural trusses. The method is based on the principle of equilibrium, which assumes that the truss members are connected by frictionless pins. The forces at each joint can be determined by considering the equilibrium of the forces acting on that joint.
Since plane truss members are in the same plane, each joint is subjected to a coplanar and concurrent force system. To apply the method of joints, the first step is to...