Adsorption of arsenate on untreated dolomite powder

Raw dolomite powder was evaluated for its efficiency in adsorbing As(V) from water. An experimental setup comprised of a fluidized dolomite powder bed was used to assess the impact of various test variables on the efficiency of removal of As(V). Test influents including distilled water (DW), synthetic groundwater (SGW) and filtered sewage effluent (FSE) were employed to assess the effect of influent parameters on the adsorption process and the quality of the effluent generated. Dolomite exhibited good As(V) removal levels for distilled water (>92%) and synthetic ground water (>84%) influents at all initial As(V) concentrations tested (0.055-0.600 ppm). Breakthrough of dolomite bed occurred after 45 bed volumes for DW and 20 bed volumes for SGW influents with complete breakthrough taking place at more than 300 bed volumes. As(V) removal from FSE influents was relatively unsuccessful as compared to the DW and SGW influents. Partial removal in the order of 32% from filtered sewage effluent at initial concentration of 0.6 mg/L started at 75 bed volumes and gradually stopped at 165 bed volumes. Varying degrees of As(V) adsorption capacities were observed by the different test influents employed, which indicate that the adsorption of As(V) is adversely affected by competing species, mainly sulfates and phosphates present in the influent. The adsorptive behavior of dolomite was described by fitting data generated from the study into the Langmuir and Freundlich isotherm models. Both models described well the adsorption of dolomite. The average isotherm adsorptive capacity was determined at 5.02 mug/g. Regeneration of the dolomite bed can be achieved with the use of caustic soda solution at a pH of 10.5.