There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.

To determine the electron configuration for any particular atom, we can build the structures in the order of atomic numbers. Beginning with hydrogen, and continuing across the periods of the periodic table, we add one proton at a time to the nucleus and one electron to the proper subshell until we have described the electron configurations of all the elements. This procedure is called the aufbau principle, from the German word aufbau (“to build up”). Each added electron occupies the...

Alkenes can be obtained from amines via an E2 elimination. The amine is first converted into a good leaving group, such as a quaternary ammonium salt. This is accomplished by treating the amine with an excess of alkyl halide, which results in a halide salt. Next, the halide salt is transformed into a hydroxide salt that functions as a base to enable elimination.
Under thermal conditions, the hydroxide can abstract a proton from the β carbon; this generates an alkene with the simultaneous...

The Hinsberg test is a method to identify primary, secondary and tertiary amines, named after its pioneer, Oscar Hinsberg. Here, amines are treated with benzenesulfonyl chloride, also known as the Hinsberg reagent, in the presence of an excess of aqueous base, followed by acidification. Based on the nature of the amines, different changes are observed.
Generally, a primary amine reacts with the Hinsberg reagent to produce an N-substituted benzenesulfonamide. The electron-withdrawing sulfonyl...

Amines are organic derivatives of ammonia. They are formed by replacing one or more ammonia protons with alkyl or aryl groups. Depending upon the number of organyl groups bonded to nitrogen, amines are classified as primary, secondary, or tertiary. Primary amines have one organyl group attached to the nitrogen atom, while secondary and tertiary amines have two and three organyl groups attached to the nitrogen atom, respectively.

Van de Graaff generators (or Van de Graaffs) are devices used to demonstrate high voltage due to static electricity that can also be used for research. Robert Van de Graaff first built one in 1931 (based on original suggestions by Lord Kelvin) for use in nuclear physics research.
Van de Graaff uses both smooth and pointed surfaces, conductors, and insulators to generate large static charges and, hence, large voltages. A substantial excess charge can be deposited on the sphere because it moves...