Related Experiment Video

Updated: Jul 14, 2026

Use of a Battery of Chemical and Ecotoxicological Methods for the Assessment of the Efficacy of Wastewater Treatment Processes to Remove Estrogenic Potency
09:49

Use of a Battery of Chemical and Ecotoxicological Methods for the Assessment of the Efficacy of Wastewater Treatment Processes to Remove Estrogenic Potency

Published on: September 11, 2016

Evaluation of toxic chemical parameters and ecotoxicity levels in bottled mineral waters

G Signorile1, A Neve, F Lugoli

  • 1University of Bari, Department of Internal and Public Medicine, Section of Hygiene, Italy. g.signorile@igiene.uniba.it

Journal of Preventive Medicine and Hygiene
|May 18, 2007
PubMed

More Related Videos

Preparation and Testing of Impedance-based Fluidic Biochips with RTgill-W1 Cells for Rapid Evaluation of Drinking Water Samples for Toxicity11:19

Preparation and Testing of Impedance-based Fluidic Biochips with RTgill-W1 Cells for Rapid Evaluation of Drinking Water Samples for Toxicity

Published on: March 7, 2016

A Toxicological and Ecotoxicological Assay Based on Mussel (Mytilus galloprovincialis) Hemocytes Motility07:28

A Toxicological and Ecotoxicological Assay Based on Mussel (Mytilus galloprovincialis) Hemocytes Motility

Published on: December 13, 2024

Related Concept Videos

Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
Toxicity Testing in Animals01:23

Toxicity Testing in Animals

Toxicity tests in animals are grounded on two main assumptions: first, the effects observed in laboratory animals can be extrapolated to humans, especially when adjusted for body surface area; second, high-dose exposure in animals is essential to identify potential human hazards from lower doses. This is based on the quantal dose-response concept, which faces the challenge of extrapolating results from relatively few test animals to much larger human populations. For example, a 0.01% incidence...
Toxic Reactions: Overview01:26

Toxic Reactions: Overview

When toxic substances penetrate the human body, they disseminate to various tissues, undergoing metabolic changes. This process yields reactive metabolites that may covalently bind with specific target molecules, resulting in toxicity.
Toxicity falls into two primary categories: local and systemic.
Local toxicity appears at the exposure site, such as protein denaturation caused by caustic substances.
In contrast, systemic toxicity requires the toxic agent's absorption and distribution,...