Related Experiment Video

Updated: Jul 14, 2026

A Rapid Method for Modeling a Variable Cycle Engine
04:58

A Rapid Method for Modeling a Variable Cycle Engine

Published on: August 13, 2019

ThermoData Engine (TDE): software implementation of the dynamic data evaluation concept. 2. Equations of state on

Vladimir Diky1, Chris D Muzny, Eric W Lemmon

  • 1Physical and Chemical Properties Division, National Institute of Standards and Technology, Boulder, Colorado 80305-3328, USA.

Journal of Chemical Information and Modeling
|May 24, 2007
PubMed

More Related Videos

Temperature-Controlled Assembly and Characterization of a Droplet Interface Bilayer10:11

Temperature-Controlled Assembly and Characterization of a Droplet Interface Bilayer

Published on: April 19, 2021

Heat Tolerance Assays Using the Drosophila Activity Monitor System: A Guide to an Executable Application for Data Analysis05:05

Heat Tolerance Assays Using the Drosophila Activity Monitor System: A Guide to an Executable Application for Data Analysis

Published on: December 13, 2024

Related Concept Videos

Thermodynamic Systems01:06

Thermodynamic Systems

A thermodynamic system is a set of objects whose thermodynamic properties are of interest. The system is considered to be embedded in its surroundings or the environment. The system and its environment can exchange heat and do work on each other through a boundary that separates them. However, the immediate surroundings of the system interact with it directly and therefore have a much stronger influence on its behavior and properties.
Consider an example of  tea boiling in a kettle. The tea and...
Thermodynamic Processes01:25

Thermodynamic Processes

A thermodynamic process is a path through a sequence of states that takes a system from an initial state to a final state. In a cyclic process, the system returns to its initial state, so the changes in state properties and state functions (ΔT, Δp, ΔV, ΔU, ΔH) over one complete cycle are zero. However, heat and work transfers can still occur during the cycle, and the net heat and net work over the cycle need not be zero.A reversible process occurs when the system is infinitesimally close to...
Statements of the Second Law of Thermodynamics01:15

Statements of the Second Law of Thermodynamics

The second law of thermodynamics can be stated in several different ways, and all of them can be shown to imply the others. The Clausius’ statement of the second law of thermodynamics is based on the irreversibility of spontaneous heat flow. It states that heat will not flow from the colder body to the hotter body unless some other process is involved. Additionally, as per the Kelvin’s statement, it is impossible to convert the heat from a single source into work without any other effect. This...
Variables and Equations of State01:27

Variables and Equations of State

The physical state of a pure substance can be defined by certain state variables such as volume (V), pressure (p), temperature (T), and amount of substance (n). When two gases are separated by a movable wall, the gas with the higher pressure naturally compresses the gas with the lower pressure. This causes the high-pressure gas to expand and the low-pressure gas to compress until both gases achieve mechanical equilibrium. At this point, their pressures equalize, and the movement of the wall...
Thermodynamic Potentials01:26

Thermodynamic Potentials

Thermodynamic potentials are state functions that are extremely useful in analyzing a thermodynamic system. They have dimensions of energy. The four important thermodynamic potentials are internal energy, enthalpy, Helmholtz free energy, and Gibbs free energy. These thermodynamic potentials can be expressed using two of the following variables: pressure, volume, temperature, and entropy. These two variables are expressed as the rate of change of the thermodynamic potential with respect to other...
Thermochemical Equations02:55

Thermochemical Equations

For a chemical reaction (the system) carried out at constant pressure – with the only work done caused by expansion or contraction – the enthalpy of reaction (also called the heat of reaction, ΔHrxn) is equal to the heat exchanged with the surroundings (qp).