Related Experiment Video

Updated: Jul 14, 2026

On-line Analysis of Nitrogen Containing Compounds in Complex Hydrocarbon Matrixes
07:49

On-line Analysis of Nitrogen Containing Compounds in Complex Hydrocarbon Matrixes

Published on: August 5, 2016

A simple correlation for predicting heats of fusion of nitroaromatic carbocyclic energetic compounds

Mohammad Hossein Keshavarz1

  • 1Department of Chemistry, Malek-ashtar University of Technology, Shahin-shahr P.O. Box 83145/115, Islamic Republic of Iran. mhkir@yahoo.com

Journal of Hazardous Materials
|June 6, 2007
PubMed

More Related Videos

Nitrogen Compound Characterization in Fuels by Multidimensional Gas Chromatography08:22

Nitrogen Compound Characterization in Fuels by Multidimensional Gas Chromatography

Published on: May 15, 2020

Combustion Chemistry of Fuels: Quantitative Speciation Data Obtained from an Atmospheric High-temperature Flow Reactor with Coupled Molecular-beam Mass Spectrometer07:24

Combustion Chemistry of Fuels: Quantitative Speciation Data Obtained from an Atmospheric High-temperature Flow Reactor with Coupled Molecular-beam Mass Spectrometer

Published on: February 19, 2018

Related Concept Videos

Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes02:14

Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes

The low reactivity in alkanes can be attributed to the non-polar nature of C–C and C–H σ bonds. Alkanes, therefore, were  initially termed as “paraffins,” derived from the Latin words: parum, meaning “too little,” and affinis, meaning “affinity.”
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified petroleum gas (LPG), fuel oil, gasoline, diesel fuel, and...
Basicity of Heterocyclic Aromatic Amines01:25

Basicity of Heterocyclic Aromatic Amines

Heterocyclic amines, where the N atom is a part of an alicyclic system, are similar in basicity to alkylamines. Interestingly, the heterocyclic amine having a nitrogen atom as part of an aromatic ring has much less basicity than its corresponding alicyclic counterpart. For this reason, as presented in Figure 1, piperidine (pKb = 2.8) is significantly more basic than pyridine (pKb = 8.8).
Mass Spectrum: Interpretation01:24

Mass Spectrum: Interpretation

An unknown compound can be established by identifying the molecular ion peak in the mass spectrum. The molecular ion peak is often weak or absent due to the predominance of fragmentation in high-energy electron beams. In such cases, a soft-energy electron beam can be used to scan the spectrum to enhance the intensity of the molecular ion peak. Additionally, chemical ionization, field ionization, and desorption ionization spectra are used to obtain a relatively intense molecular ion peak.To...
Enthalpies of Reaction03:33

Enthalpies of Reaction

Hess’s law can be used to determine the enthalpy change of any reaction if the corresponding enthalpies of formation of the reactants and products are available. The main reaction may be divided into stepwise reactions : (i) decompositions of the reactants into their component elements, for which the enthalpy changes are proportional to the negative of the enthalpies of formation of the reactants, −ΔHf°(reactants), followed by (ii) re-combinations of the elements (obtained in step 1) to give...
Standard Enthalpy of Formation02:37

Standard Enthalpy of Formation

Enthalpy changes are typically tabulated for reactions in which both the reactants and products are at the same conditions. A standard state is a commonly accepted set of conditions used as a reference point for the determination of properties under other different conditions. For chemists, the IUPAC standard state refers to materials under a pressure of 1 bar and solutions at 1 M and does not specify a temperature. Many thermochemical tables list values with a standard state of 1 atm. Because...
Enthalpy and Heat of Reaction02:12

Enthalpy and Heat of Reaction

Combustion, commonly known as burning, is a reaction in which a substance reacts with an oxidizing agent, which in most cases is molecular oxygen, to liberate energy in the form of heat, light, or sound. The heat of combustion is also known as the enthalpy of combustion. The energy released when one mole of a substance undergoes complete combustion at constant pressure is called molar heat of combustion. Combustion reactions are exothermic; that is, they release energy, and their ΔH sign...