Related Experiment Video
Updated: Jul 14, 2026
Comparing Objective Conjunctival Hyperemia Grading and the Ocular Surface Disease Index Score in Dry Eye Syndrome During COVID-19
Published on: May 25, 2022
Assessment of variation in bulbar conjunctival redness, temperature, and blood flow
Stephanie Duench1, Trefford Simpson, Lyndon W Jones
1Centre for Contact Lens Research, School of Optometry, University of Waterloo, 200 University Avenue, Waterloo, Ontario, Canada. svaccari@scimail.uwaterloo.ca
Purpose:
To assess the diurnal variation in bulbar conjunctival redness, conjunctival temperature, and conjunctival blood flow.
Methods:
Bulbar redness was quantified by CIE u' chromaticity using a SpectraScan PR650 spectrophotometer. Conjunctival temperature was measured using a Tasco-Thi 500 infrared thermometer. Measurements of conjunctival blood flow were obtained using a modified Heidelberg Retinal Flowmeter (HRF). Measurements on 10 subjects were made on a periodic basis over the day and on waking.
Results:
For each factor measured a cyclical pattern was observed, with highest values on waking, a reduction in values towards mid-day, and then a gradual increase over the remainder of the day. There was a significant effect of time for redness, temperature, and conjunctival blood flow (p < 0.001 for all three variables), with no significant difference in the cyclical pattern between eyes being observed (p = NS).
Conclusions:
Diurnal bulbar redness, temperature, and conjunctival blood flow variation may be objectively quantified and all three are lowest during the middle of the day and maximal at the start of the day. This information should be considered when undertaking studies in which redness, temperature, and ocular surface blood flow are important outcome variables and time of day is a potential confounding factor.
More Related Videos
Related Concept Videos
01:19Assessing Body Temperature - Temporal Artery
Step 1: Perform hand hygiene and don a fresh pair of gloves to prevent cross-infection and ensure patient safety.
Step 2: Explain the procedure to the patient to establish trust. Clear communication establishes trust with the patient, ensures they understand what to expect, promotes cooperation, and enhances comfort during the procedure.
Step 3: Assess the patient's forehead...
01:27Assessment of the Cardiovascular System III: Palpation
Jugular Venous Pressure (JVP) Measurement
Position the patient at a thirty- to forty-five-degree angle or in a semi-fowler's position. Look for the highest point of pulsation in the internal jugular vein and measure the vertical distance to the angle of Loius or sternal angle. A normal JVP is 3-4 cm above the...
01:27Assessing Body Temperature - Rectal
Follow these steps for rectal temperature assessment:
Step 1: Perform hand hygiene and don clean gloves to prevent cross-infection.
Step 2: Position the patient in a side-lying position to better visualize the rectal...
01:14Assessing Body Temperature - Oral
Step 1:
Start by practicing proper hand hygiene to prevent the spread of microorganisms.
Step 2:
Take the thermometer out of the charging unit, switch it on, and wait for the ready sign.
Step 3:
Gently slide the probe cover until a click is heard. This simple action prevents cross-contamination and ensures the correct placement of the probe cover.
Step 4:
Instruct the patient to open their mouth and place...
01:14Assessing Body Temperature - Tympanic membrane
Step 1: Begin by practicing good hand hygiene to prevent the transmission of microorganisms.
Step 2: Turn on the thermometer and wait until the ready sign appears on the screen to ensure accurate measurement.
Step 3: Slide the probe cover in place to prevent cross-contamination.
Step 4: Instruct the patient to tilt their head to the side for comfort and check for cerumen...