Related Experiment Video
Updated: Jul 14, 2026

Imaging of Biological Tissues by Desorption Electrospray Ionization Mass Spectrometry
Published on: July 12, 2013
Surface scanning analysis of planar arrays of analytes with desorption electrospray ionization-mass spectrometry
Sofie P Pasilis1, Vilmos Kertesz, Gary J Van Berkel
1Organic and Biological Mass Spectrometry Group, Chemical Sciences Division, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831-6131, USA.
Abstract:
The analysis of analytes deposited on, separated on, or otherwise distributed about a planar surface using desorption electrospray ionization mass spectrometry in a surface scanning sampling mode was investigated. The physical regions of the surface-impacting solvent/gas jet desorption/ionization plume were described. Under the conditions typical for desorption electrospray ionization used here, the impact plume formed an elliptical desorption/ionization region on the surface. Most effective desorption/ionization was obtained from a smaller elliptical area within the larger impact region that was centered on a point on-axis from the sprayer tip to the surface. Maximum signal from a given amount of material on a surface was observed with proper plume and sample alignment when the diameter of the sample spot was less than the diameter of the central high-efficiency desorption/ionization region of the impact plume. Solvent and gas flow out of this high-efficiency desorption/ionization region was found to limit analyte accessibility to this region via a "washing effect" when analytes were on smooth surfaces or on surfaces for which the analyte had little affinity. As such, the direction of surface scanning and scan speed during an analysis was found to be important for maximizing signal levels and signal reproducibility on particular surface types. Overall, the results presented illustrate means to improve analysis of sample spots on various types of surfaces using desorption electrospray ionization mass spectrometry in a surface scanning mode.
Related Concept Videos
Electrospray Ionization (ESI) Mass Spectrometry
ESI utilizes electrical energy to transfer ions from the liquid phase of the sample into the...
MALDI-TOF Mass Spectrometry
Matrix-Assisted Laser Desorption Ionization (MALDI)
Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation
There are three main types of inductively coupled plasma atomic emission spectroscopy (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used.
Mass Spectrometry: Complex Analysis
GC–MS is a powerful hyphenated method commonly used in forensics and environmental...
Mass Analyzers: Common Types
