Related Experiment Video
Updated: Jan 27, 2026
Metacarpal Small Incision for Carpal Tunnel Syndrome
Published on: April 5, 2024
Thumb abduction strength measurement in carpal tunnel syndrome
Steven S Agabegi1, Richard A Freiberg, James M Plunkett
1Department of Orthopaedic Surgery, University of Cincinnati, and The Hand Surgery Center, Cincinnati, OH 45267-0212, USA. agabegis@yahoo.com
Purpose:
The strength of thumb abduction and index finger flexion was measured with a load cell mounted on a custom-made device. The resulting ratio (thumb-index ratio, or TIR) was used to diagnose carpal tunnel syndrome (CTS) and was compared with the gold standard (electrodiagnostic studies). The ratio was used as an internal control in each subject.
Methods:
Sixty-one patients (80 hands) with a clinically and electrodiagnostically confirmed diagnosis of idiopathic CTS and a control group of 51 asymptomatic volunteers (102 hands) were evaluated. The strength of thumb abduction and index finger flexion was measured in standardized fashion in each hand three times, and the mean was taken to calculate TIR.
Results:
Thumb-index ratio was statistically significant in differentiating between a CTS patient and a normal control. A TIR of 0.51 had a 98% specificity and a 92% positive predictive value for diagnosing CTS. Thumb-index ratio greater than 0.51 was neither sensitive nor specific for diagnosis of CTS. Twenty-four (30%) hands in the investigational group had a TIR < or =0.51 compared with 1 hand (1%) in the control group. There was a significant difference in the TIR between hands with a motor amplitude of < or =4.0 mV and those with an amplitude >4.0 mV.
Conclusions:
Most patients with CTS do not appear to have notable weakness of thumb abduction strength. A TIR < or =0.51 had high specificity for differentiating between CTS and controls. However, the performance of this device needs to be evaluated in a general population of patients who present with signs and symptoms of CTS before it would be clinically applicable.
Related Concept Videos
03:05Acid Strength and Molecular Structure
In the absence of any leveling effect, the acid strength of binary compounds of hydrogen with nonmetals (A) increases as the H-A bond strength decreases down a group in the periodic table. For group 17, the order of increasing acidity is HF < HCl < HBr < HI. Likewise, for group 16, the order of increasing acid strength is H2O < H2S < H2Se < H2Te. Across a row in the periodic table, the acid strength of binary hydrogen compounds increases with increasing...
02:18The Equilibrium Binding Constant and Binding Strength
01:20Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
01:30Relation Between Tensile Strength and Compressive Strength of Concrete
01:13Range Rule of Thumb to Interpret Standard Deviation
For instance, the range rule of thumb can be used to find the tallest and the shortest student in a class, given the mean student height and standard deviation. If the mean student height is 1.6 m and the standard deviation, s is 0.05 m, the height...
01:29Strength and Heat of Hydration
The heat of hydration for each cement compound is significant; for instance, tricalcium aluminate (C3A) and...