Related Experiment Video
Updated: Jul 13, 2026

Tracking Infiltration Front Depth Using Time-lapse Multi-offset Gathers Collected with Array Antenna Ground Penetrating Radar
Published on: May 1, 2018
A new definition of boundary point between early reflections and late reverberation in room impulse responses
Takayuki Hidaka1, Yoshinari Yamada, Takehiko Nakagawa
1Takenaka R&D Institute, Otsuka, Inzai, Chiba, Japan. hidaka.takayuki@takenaka.co.jp
Abstract:
The early reflections in the room impulse response are usually defined as those observed within the initial 80 ms after the arrival of the direct sound, after which time the sound field is called reverberant. This number was chosen from measurements of other functions in a limited number of halls. In order to give an objective foundation to this time separation and to establish a physical indicator for it, a new method is proposed that defines a "transition time t(L)," which is the time at which the energy correlation between the direct plus initial sound and the subsequent decaying sound first achieves a specified low value. For various halls this number is shown and its relevance as a new parameter is discussed.
Related Concept Videos
Impulse Response
Kirchhoff's law forms an input signal equation, with the capacitor's current and voltage providing the output. Substituting the current and dividing by RC yields a differential equation. The output for an impulse input is the impulse...
Echo
Imagine the sound is reflected back to the ears. Assuming that the source is very close to the human, the difference between hearing the two sounds—the emitted sound and the reflected sound—may be more than the minimum time for perceiving distinct sounds. If this is the case, then the...
Reflection of Waves
Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
Boundary Conditions: Lossless Lines
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
Sound Waves: Interference

