[Impact of proportion of adding raw wastewater on post-treatment of digested piggery wastewater]

Sequencing batch reactor (SBR) was used to treat digested piggery wastewater, in order to investigate the impact of proportion of adding raw wastewater. In consecutive experiments, the reactor with adding 30% raw wastewater could get low ammonia nitrogen (NH3-N), usually less than 10 mg/L in the effluent, while the reactors with adding 10% or 20% raw wastewater, concentration of NH3-N increased by degrees until reached 300 mg/L or 80 mg/L respectively at end of experiment. These can be explained by the facts that the reactor with adding 30% raw wastewater could maintain stable pH (about 7.7), whereas pH in the reactors with adding 10% or 20% raw wastewater decreased gradually until to below 5.5. Performance monitoring of a cycle of SBR indicate that the peak value of nitrite nitrogen (NO2(-)-N) and valley value of ammonia nitrogen (NH3-N) occur in the fourth, third and second hour after aeration beginning for the reactors with adding 10%, 20% and 30% raw wastewater respectively, which imply that the more is the proportion of adding raw wastewater, the fast does the ammonia oxidized. These results can be attributed to the facts the higher proportion of adding raw wastewater brought better denitrification resulting in stable and high pH. The batch experiment shows that the rate of denitrification has positive correlation with ratio of BOD5 to TN in influent. The consecutive and batch experiment all prove the proportion of adding raw wastewater must reach more than 30% for normal operation of post-treatment of digested piggery wastewater.