Related Experiment Video
Updated: Jul 13, 2026

Building Finite Element Models to Investigate Zebrafish Jaw Biomechanics
Published on: December 3, 2016
Comparison of stress zones in finite element models of deformed bovine claw capsules
C Hinterhofer1, V Apprich, E Polsterer
1Clinic for Orthopedics in Ungulates, University of Veterinary Medicine, Vienna, Austria. christine.hinterhofer@vet-hiho.at
Abstract:
Pathological claw formations occur subsequent to irregular or prolonged claw trimming periods and as a result of improper flooring. Clinical experience and material testing finds horn of minor quality to be associated with the malformations. Finite element models (FEM) of a flat claw (FC), a contracted claw (CC), and a laminitic claw (LC) were designed from native claw specimens to combine material properties and altered claw geometry for stress analysis. The FEM were created by digitizing the typically deformed exungulated claw capsule by means of computed tomography or digital photography. The derived geometry data were meshed with finite elements and the material properties were attributed. Loading was performed via vertical load vectors according to the suspensory and support apparatus of the bovine digit. All FEM were loaded on soft floors. Loading of the FEM of the FC with 756 N exhibited maximum stress values of 3.32 MPa in the dorsal wall, that of the CC exhibited comparably lower stress of 1.33 MPa in the distal abaxial wall, and the model of the LC showed maximum stress of 4.51 MPa in the region of the dorsal border, all at the same loading. The solar surfaces and the corresponding imprints showed stress concentrations in the palmar aspect of the bulb in the FC, a highly stressed bearing margin of the abaxial wall in the CC, and a diffusely stressed sole and bulb in the LC in contrast to the sound claw models. The FEM of the selected pathological claw forms (FC, CC, LC) calculated high stress zones exactly at locations in the claw wall and sole where clinical experts expect the typical claw lesions for these pathologies. These results were obtained simply by exchanging the outer form of the claw capsules; the method of loading and type of flooring for these pathological models were equivalent to those of the sound FEM. It is highly possible that the stress zones derived from these calculations represent corium compression in reality, and these data support the pathophysiological theory that claw lesions may arise as a consequence thereof.
Related Concept Videos
Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes.
Stress-Strain Diagram - Ductile Materials
Deformation of Member under Multiple Loadings
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
Normal Strain under Axial Loading
Elastic Strain Energy for Shearing Stresses
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
