Production of BSA-loaded alginate microcapsules: influence of spray dryer parameters on the microcapsule...

The aim of this study was to optimize the production of BSA-loaded alginate microcapsules by spray drying and to study the release of bovine serum albumin fraction V (BSA) under gastric simulated conditions. Microcapsule yield, BSA release, microcapsule size and size distribution were characterized following the application of different production parameters including inlet air temperature, inlet air pressure and liquid feed rate. The microcapsules were incubated in 0.1 N HCl and BSA release was quantified over time. The yields were higher with the pressure of 3 bar compared to 4 bar and with a feed rate of 0.45 vs. 0.2 ml s(-1). A high feed rate (0.45 vs. 0.2 ml s(-1)) allows one to obtain microcapsules with a low BSA release (p = 0.0327). The increase of the atomizer inlet temperature leads to microcapsules with a higher BSA release (p = 0.0230). A higher air pressure of 4 bar compared to 3 bar resulted in a lower microcapsule size (2.55 vs. 2.80 microm) and led to a narrower size distribution (0.92 vs. 1.07). In conclusion, the spray dryer parameters influenced the alginate microcapsule characteristics as well as subsequent protein release into a simulated gastric medium.