Achieving Gaussian outputs from large-mode-area higher-order-mode fibers

We describe an alternative to fiber-gratings for converting higher-order LP(0m) (m>1) fiber modes into a nearly fundamental Gaussian shape at the output of a fiber. This schematic enables the use of light propagation in higher-order modes of a fiber, a fiber-platform that has recently shown great promise for achieving very large mode areas needed for future high-power lasers and amplifiers. The conversion will be done by using a binary phase plate in the near field of the fiber, which emits the LP(0m) mode. Since the binary phase plate alone cannot increase the quality factor M(2) of the laser beam because of some broad sidebands, a filtering of the sidebands is done in the Fourier plane of a telescope. Of course, this will cost some of the total light power, but on the other side the M(2) factor can be reduced to nearly the ideal value near 1.0, and it is shown that approximately 76% of the total light power can be conserved for all investigated modes (2