Factors affecting the morphology of benzoyl peroxide microsponges

Benzoyl peroxide (BPO) is primarily used in the treatment of mild to moderate acne. However, its application is associated with skin irritation. It has been shown that encapsulation and controlled release of BPO could reduce the side effect while also reducing percutaneous absorption when administered to the skin. The aim of the present investigation was to design and formulate an appropriate encapsulated form of BPO, using microsponge technology, and explore the parameters affecting the morphology and other characteristics of the resultant products employing scanning electron microscopy (SEM). Benzoyl peroxide particles were prepared using an emulsion solvent diffusion method by adding an organic internal phase containing benzoyl peroxide, ethyl cellulose and dichloromethane into a stirred aqueous phase containing polyvinyl alcohol (PVA). Different concentrations of BPO microsponges were incorporated in lotion formulations and the drug release from these formulations were studied. The SEM micrographs of the BPO microsponges enabled measurement of their size and showed that they were spherical and porous. Results showed that the morphology and particle size of microsponges were affected by drug:polymer ratio, stirring rate and the amount of emulsifier used. The results obtained also showed that an increase in the ratio of drug:polymer resulted in a reduction in the release rate of BPO from the microsponges. The release data showed that the highest and the lowest release rates were obtained from lotions containing plain BPO particles and BPO microsponges with the drug:polymer ratio of 13:1, respectively. The kinetics of release study showed that the release data followed Peppas model and the main mechanism of drug release from BPO microsponges was diffusion.