Related Experiment Video

Updated: Jul 13, 2026

Evaluation of an Exclusive Spur Dike U-Turn Design with Radar-Collected Data and Simulation
11:41

Evaluation of an Exclusive Spur Dike U-Turn Design with Radar-Collected Data and Simulation

Published on: February 1, 2020

Rounding a corner of a bent termite tunnel and tunnel traffic efficiency

Sang-Hee Lee1, Paul Bardunias, Nan-Yao Su

  • 1Department of Entomology and Nematology, Ft. Lauderdale Research and Education Center, University of Florida, 3205 College Avenue, Ft. Lauderdale, FL 33314, USA.

Behavioural Processes
|August 21, 2007
PubMed

More Related Videos

Detection and Quantification of Tunneling Nanotubes Using 3D Volume View Images12:45

Detection and Quantification of Tunneling Nanotubes Using 3D Volume View Images

Published on: August 31, 2022

Related Concept Videos

Optimization Problems01:26

Optimization Problems

Optimization problems often involve identifying maximum or minimum values under specific constraints. A well-known example is determining the longest horizontal pipe that can be moved around a right-angled corner, where a 3-meter-wide hallway meets a 2-meter-wide hallway. This scenario, common in architectural design and industrial transport, can be understood conceptually through geometric and trigonometric reasoning.To visualize the problem, consider the pipe as a straight line that touches...
Design Example: Traverse Angle Computations01:25

Design Example: Traverse Angle Computations

Traverse angle computations are a critical component of surveying, used to compute the internal angles within a closed traverse. A traverse consists of a series of connected lines forming a closed loop, often used for land boundary delineation or mapping. Calculating the internal angles ensures accuracy in the traverse geometry and is essential for checking survey data integrity.The process begins with known azimuths and bearings of the traverse sides. Internal angles at each vertex are...
Introduction to Vertical Curves01:24

Introduction to Vertical Curves

Vertical curves are parabolic transitions that connect different grades on highways and railroads, ensuring a smooth alignment between back and forward tangents. The back tangent represents the initial grade, while the forward tangent defines the subsequent grade. These curves can be symmetrical, with equal tangent lengths, or nonsymmetrical, with varying lengths. The key points defining a vertical curve include the Point of Vertical Intersection (P.V.I.), where the tangents meet; the Point of...
Adjusting a Traverse01:12

Adjusting a Traverse

In the site survey of a four-sided traverse, internal angles are essential to ensure geometric accuracy. The survey revealed that the sum of the measured internal angles was 359 degrees and 48 minutes, which is 12 minutes less than the expected 360 degrees. This discrepancy signals an error likely arising from measurement inaccuracies during the fieldwork.To rectify this error, the adjustment process involved distributing the 12-minute shortfall equally across the four internal angles. By...
Brick Cutting Techniques01:08

Brick Cutting Techniques

Brick-cutting techniques involve various tools and methods to shape bricks for construction. A mason's hammer with a chisel-pointed end is used for basic shaping through sharp, precise strikes. For more complex shapes requiring higher precision, a power saw with a water-cooled diamond blade is used.
Cut bricks are categorized by size. Bricks cut to half their original length are called half-bats, while those cut to three-fourths their length are known as three-fourth bats.
Special types of cut...
Introduction to Horizontal Curves01:19

Introduction to Horizontal Curves

Horizontal curves are essential in highway and railroad design, ensuring smooth and safe transitions between straight path segments, or tangents. These curves allow vehicles to maintain speed without abrupt changes, minimizing accidents and improving travel efficiency.A horizontal curve is typically defined by its geometric relationship to two tangents that meet at an intersection point (P.I.), where a simple curve is introduced to connect them. The back tangent refers to the initial tangent...