Routine hydrogen isotope measurement of cellulose nitrate by high-temperature pyrolysis--reference materials and...

The determination of isotope ratios of non-exchangeable hydrogen in tree-ring cellulose is commonly based on the nitration of wood cellulose followed by online high-temperature pyrolysis and isotope ratio mass spectrometry measurement of cellulose nitrate samples. The application of this method requires a proper calibration using appropriate reference materials whose delta(2)H values have been reliably normalized to the V-SMOW/SLAP scale. In our study, we achieve this normalization by a direct alternating measurement of reference waters (V-SMOW and SLAP) and three cellulose nitrates chosen as reference materials. For that purpose, both water and solid organic samples are introduced into the pyrolysis reactor by silver capsule injection. The analytical precision of the water measurement using the capsule method is +/-1.5 per thousand. The hydrogen isotopic composition of three cellulose nitrate standards measured ranges from -106.7 to -53.9 per thousand. The standard deviation of the calculated means from five measurement periods of those standards is better than 1 per thousand. Twenty-four different measurements of the hydrogen isotope composition of cellulose nitrate were evaluated in order to assess the precision of the described method. We obtained an analytical precision of +/-3.0 per thousand as representative for the 95% confidence interval applicable for routine measurements of cellulose nitrate samples. Evidence was found for significant differences in the behavior of cellulose nitrate and PE foil during the pyrolitic conversion that emphasizes the need for a proper calibration of the routine measurements. This calibration can only be successful if the reference materials used have a very similar chemical composition and undergo the same preparation procedure as the samples.