Related Experiment Video
Updated: Jul 12, 2026

A Continuous-flow Photocatalytic Reactor for the Precisely Controlled Deposition of Metallic Nanoparticles
Published on: April 10, 2019
Development of cloud point extraction for simultaneous extraction and determination of gold and palladium using
Laleh Tavakoli1, Yadollah Yamini, Homeyra Ebrahimzadeh
1Department of Chemistry, Faculty of Sciences, Payame Noor University, Mashhad, Iran.
Abstract:
Cloud point method was applied for the simultaneous extraction and preconcentration of trace amounts of gold and palladium. The extraction of analytes was performed in the presence of 1,8-diamino-4,5-dihydroxy anthraquinone as chelating agent and Triton X-114 as a non-ionic surfactant. After phase separation, the surfactant-rich phase was diluted with concentrated HNO(3) (65%, w/w) and the analytes concentrations were determined by inductively coupled plasma-optical emission spectrometry (ICP-OES). The variables affecting the complexation and extraction conditions were optimized and under the optimum conditions (i.e. pH 6.5, 2.2 x 10(-4) mol l(-1) chelating agent, 0.15% (w/v) of Triton X-114, equilibration temperature 55 degrees C, centrifuge at 3500 rpm), quantitative extraction of Au(III) and Pd(II) from 100 ml of the aqueous solution was performed. The calibration curves were linear in the range of 0.5-1000 microg l(-1) with detection limits of 0.5 and 0.3 microg l(-1) and the enrichment factors were 8.6 and 20.2 for Au and Pd, respectively. Also the precision (%RSD) for eight replicate determinations of the analytes was better than 5%. Finally, the proposed method was successfully applied for the determination of Au and Pd in mine stones and standard reference materials (SRM).
More Related Videos
10:31Detection and Recovery of Palladium, Gold and Cobalt Metals from the Urban Mine Using Novel Sensors/Adsorbents Designated with Nanoscale Wagon-wheel-shaped Pores
Published on: December 6, 2015
09:51Standards for Quantitative Metalloproteomic Analysis Using Size Exclusion ICP-MS
Published on: April 13, 2016
Related Concept Videos
Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle
The ions and electrons produced interact with the fluctuating magnetic field created by a water-cooled...
Inductively Coupled Plasma–Mass Spectrometry (ICP–MS): Overview
Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation
There are three main types of inductively coupled plasma atomic emission spectroscopy (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used.
Precipitation Titration: Endpoint Detection Methods
In the Volhard method, a standard excess of AgNO3 is first added to the...
Inductively Coupled Plasma-Mass Spectrometry (ICP-MS): Interferences
Atomic Emission Spectroscopy: Lab