Deleterious substances in aggregates can be detrimental to the quality and durability of concrete. These substances include organic impurities like loam, which interfere with cement hydration and are usually present in the sand. These prevent a good bond between aggregate and cement paste. Organic impurities can be detected using the colorimetric test, where the darkness of a solution after agitation indicates the level of organic content.
Another type of impurity is clay and fine material that...

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...

Concrete exposed to seawater can undergo degradation like the dissolution of ettringite and gypsum, increasing the material's porosity and decreasing its strength. In contrast, the crystallization of salts within the concrete's pores can cause expansion, particularly above the waterline where evaporation occurs. Nonetheless, this expansion only happens when seawater, enabled by the concrete's permeability, manages to infiltrate the structure.
Concrete in areas between tide marks, which undergo...

Marine microbial ecosystems are shaped by distinct physicochemical limits, including high salinity, low nutrient availability, and fluctuating oxygen levels. These conditions favor smaller microbial cell sizes, which maximize their surface-to-volume ratio for efficient nutrient uptake.Microbial activity and community composition are closely linked to biogeochemical cycles, particularly in dynamic environments like estuaries, where halotolerant microbes thrive in response to variable salinity...

The deep ocean and its underlying sediments represent vast, largely unexplored microbial habitats that extend far beyond the sunlit photic zone. The photic (euphotic) zone typically spans the upper ~100–200 meters of pelagic waters in the open ocean, but its depth varies geographically and seasonally, where sufficient light supports photosynthetic life. Below this lies the deep sea, spanning roughly 1000–6000 meters (bathypelagic to abyssal zones), with deeper hadal trenches extending beyond...