Related Experiment Video

Updated: Jul 12, 2026

Reaction Kinetics and Combustion Dynamics of I4O9 and Aluminum Mixtures
09:16

Reaction Kinetics and Combustion Dynamics of I4O9 and Aluminum Mixtures

Published on: November 7, 2016

Ice nuclei from automobile exhaust and iodine vapor

V J Schaefer

    Science (New York, N.Y.)
    |December 23, 1966
    PubMed

    More Related Videos

    An Efficient Method for Selective Desalination of Radioactive Iodine Anions by Using Gold Nanoparticles-Embedded Membrane Filter07:28

    An Efficient Method for Selective Desalination of Radioactive Iodine Anions by Using Gold Nanoparticles-Embedded Membrane Filter

    Published on: July 13, 2018

    Synthesis and Purification of Iodoaziridines Involving Quantitative Selection of the Optimal Stationary Phase for Chromatography10:14

    Synthesis and Purification of Iodoaziridines Involving Quantitative Selection of the Optimal Stationary Phase for Chromatography

    Published on: May 16, 2014

    Related Concept Videos

    Atomic Absorption Spectroscopy: Atomization Methods01:25

    Atomic Absorption Spectroscopy: Atomization Methods

    Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the aerosol...
    Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene01:13

    Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene

    Bromination and chlorination of aromatic rings by electrophilic aromatic substitution reactions are easily achieved, but fluorination and iodination are difficult to achieve. Fluorine is so reactive that its reaction with benzene is difficult to control, resulting in poor yields of monofluoroaromatic products. To address this, Selectfluor reagent is used as a fluorine source in which a fluorine atom is bonded to a positively charged nitrogen.
    Atomic Emission Spectroscopy: Interference01:30

    Atomic Emission Spectroscopy: Interference

    In atomic emission spectroscopy (AES), high-temperature atomizers excite a broad range of elements and molecules that generate complex emissions from sources such as oxides, hydroxides, and flame combustion products in the flame or plasma. Several strategies can be employed to minimize spectral interferences caused by overlapping emission lines or bands. These include increasing instrument resolution, choosing alternative emission lines, optimally placing the detector in low-background regions,...
    Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle01:19

    Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle

    Inductively coupled plasma (ICP) is the most widely used plasma source in atomic emission spectroscopy (AES), also known as Inductively Coupled Plasma Optical Emission Spectroscopy (ICP-OES). The ICP source, or torch, consists of three concentric quartz tubes with argon gas flowing through them. A spark from a Tesla coil initiates the ionization of argon, generating a high-temperature plasma.
    The ions and electrons produced interact with the fluctuating magnetic field created by a water-cooled...
    Redox Titration: Iodimetry and Iodometry01:23

    Redox Titration: Iodimetry and Iodometry

    Iodometry and iodimetry are analytical methods used to determine the concentration of oxidizing or reducing agents using iodine. In iodometric titrations, the oxidizing analyte solution is usually acidified and treated with an excess of iodide ions, which generates an equivalent amount of iodine in equilibrium with triiodide. The released iodine is subsequently titrated directly against a standardized reducing agent. As the dilute iodine color becomes pale yellow, a few drops of freshly...
    Atomic Emission Spectroscopy: Instrumentation01:22

    Atomic Emission Spectroscopy: Instrumentation

    The instrumentation of atomic emission spectrometry (AES) involves various components, including atomization devices that convert samples into gas-phase atoms and ions. There are two main types of atomization devices: continuous and discrete atomizers.  Continuous atomizers, like plasmas and flames, introduce samples in a constant stream, while discrete atomizers inject individual samples using syringes or autosamplers. The most common discrete atomizer is the electrothermal atomizer.