Petroleum drilling and production in the United States: yield per effort and net energy analysis

Science (New York, N.Y.)
|February 6, 1981
PubMed

Related Concept Videos

Production Efficiency01:01

Production Efficiency

Net production efficiency (NPE) is the efficiency at which organisms assimilate energy into biomass for the next trophic level. Due to low metabolic rates and less energy spent on thermoregulatory processes, the NPE of ectotherms (cold-blooded animals) is 10 times higher than endotherms (warm-blooded animals).
Biofuels01:25

Biofuels

The microbial conversion of organic matter into biofuels holds potential as a renewable energy source. Among biofuel sources, microalgae are recognized as a highly efficient and adaptable feedstock for biodiesel production, owing to their rapid biomass accumulation, elevated lipid productivity, and capacity to proliferate in diverse aquatic systems, including freshwater, marine, and wastewater habitats. Unlike terrestrial crops, microalgae do not compete for land and can achieve significantly...
Primary Production01:06

Primary Production

The total amount of energy acquired by primary producers in an ecosystem is called gross primary production (GPP). However, of this energy, producers use some for metabolic processes, and some is lost as heat, decreasing the amount of energy available to the next trophic level. The remaining usable amount of energy is called the net primary productivity (NPP). In terrestrial ecosystems, NPP is driven by climate, while light penetration and nutrient availability drive NPP in aquatic ecosystems.
Standard Enthalpy of Formation02:37

Standard Enthalpy of Formation

Enthalpy changes are typically tabulated for reactions in which both the reactants and products are at the same conditions. A standard state is a commonly accepted set of conditions used as a reference point for the determination of properties under other different conditions. For chemists, the IUPAC standard state refers to materials under a pressure of 1 bar and solutions at 1 M and does not specify a temperature. Many thermochemical tables list values with a standard state of 1 atm. Because...
Application of the Energy Equation01:04

Application of the Energy Equation

The application of the energy equation to centrifugal pumps is a fundamental principle in fluid dynamics and engineering. In this scenario, the energy equation is used to calculate the flow rate of a centrifugal pump responsible for transferring water between two reservoirs at different elevations. The pump applies an energy input of 7500 joules per second, and the vertical difference between the lower and upper reservoirs is 10 meters. Additionally, the head loss due to friction and other...
Energy Budgets and Reproductive Strategies00:51

Energy Budgets and Reproductive Strategies

Organisms must balance energy intake with the energy required for growth, maintenance, and reproduction. These trade-offs result in a variety of survivorship and reproductive strategies, including semelparity and iteroparity. Semelparous species reproduce only once in their lifetime, often investing most available resources into that single reproductive event. Iteroparous species, by contrast, reproduce multiple times over their lifetimes, typically allocating fewer resources to any single...