Related Experiment Video
Updated: Jul 11, 2026

Sound Source Localization Testing in Single-sided Deafness Following Bone Conduction Intervention
Published on: December 20, 2024
Effect of low-frequency gain and venting effects on the benefit derived from directionality and noise reduction in
Gitte Keidser1, Lyndal Carter, Josef Chalupper
1National Acoustic Laboratories, Chatswood, Australia. gitte.keidser@nal.gov.au
Abstract:
When the frequency range over which vent-transmitted sound dominates amplification increases, the potential benefit from directional microphones and noise reduction decreases. Fitted with clinically appropriate vent sizes, 23 aided listeners with varying low-frequency hearing thresholds evaluated six schemes comprising three levels of gain at 250 Hz (0, 6, and 12 dB) combined with two features (directional microphone and noise reduction) enabled or disabled in the field. The low-frequency gain was 0 dB for vent-dominated sound, while the higher gains were achieved by amplifier-dominated sounds. A majority of listeners preferred 0-dB gain at 250 Hz and the features enabled. While the amount of low-frequency gain had no significant effect on speech recognition in noise or horizontal localization, speech recognition and front/back discrimination were significantly improved when the features were enabled, even when vent-transmitted sound dominated the low frequencies. The clinical implication is that there is no need to increase low-frequency gain to compensate for vent effects to achieve benefit from directionality and noise reduction over a wider frequency range.
Related Concept Videos
The Cochlea
Effects of feedback
Feedback significantly modifies the gain of a control system. The gain of a system without feedback is altered by a factor of one plus GH, where G represents...
Frequency Response of Op Amp Circuits
Frequency Response and Gain:
The gain of the op-amp, A(ω), is not a constant but a function of the input signal frequency. An op-amp can maintain a constant gain at low frequencies, known...
Characteristics of Practical Op Amps
The ratio of differential gain to the common-mode gain is defined as the common-mode rejection ratio (CMRR). This ratio quantifies the ability of operational amplifiers (op-amps) to reject common-mode...
Bode Plots
A network function represents the ratio of a system's output to its input, with the magnitude and phase angle derived from the complex network function. The decibel logarithmic gain is...
Frequency Response of BJT
Low-Frequency Response: At low frequencies, the behavior of the BJT is determined by its DC bias point, which is set by the...

