Jove
Visualize
Contact Us
JoVE
x logofacebook logolinkedin logoyoutube logo
ABOUT JoVE
OverviewLeadershipBlogJoVE Help Center
AUTHORS
Publishing ProcessEditorial BoardScope & PoliciesPeer ReviewFAQSubmit
LIBRARIANS
TestimonialsSubscriptionsAccessResourcesLibrary Advisory BoardFAQ
RESEARCH
JoVE JournalMethods CollectionsJoVE Encyclopedia of ExperimentsArchive
EDUCATION
JoVE CoreJoVE BusinessJoVE Science EducationJoVE Lab ManualFaculty Resource CenterFaculty Site
Terms & Conditions of Use
Privacy Policy
Policies

Related Concept Videos

Cascaded Op Amps01:16

Cascaded Op Amps

Operational amplifiers (op-amps) are versatile electronic components that can be interconnected in a cascade - one after another in a linear sequence. This cascading is possible due to their infinite input resistance and zero output resistance, allowing them to maintain their input-output relationships even when connected in series.
In a cascaded system, each op-amp is referred to as a stage. The output of one stage drives the input of the subsequent stage. As the input signal passes through...
MOSFET Amplifiers01:17

MOSFET Amplifiers

The MOSFET, when operating in its active region, functions as a voltage-controlled current source. In this region, the gate-to-source voltage controls the drain current. This principle underlies the operation of the transconductance MOSFET amplifier. The output current is directed through a load resistor to convert this amplifier into a voltage amplifier. The output voltage is then obtained by subtracting the voltage drop across the load resistance from the supply voltage. This process results...
Small-Signal Analysis of MOSFET Amplifiers01:23

Small-Signal Analysis of MOSFET Amplifiers

In small-signal analysis, a MOSFET transistor amplifier acts as a linear amplifier when operating in its saturation region. The gate-to-source voltage (VGS) of the MOSFET is the sum of the DC biasing voltage and the small time-varying input signal. This combination sets up the operating point and modulates the drain current (ID) that flows from the drain to the source. When a small AC signal is superimposed on the DC bias voltage at the gate, the instantaneous drain current comprises three...
Biasing of FET01:22

Biasing of FET

Biasing a Junction Field Effect Transistor (JFET) is crucial for setting operational parameters and ensuring efficient functioning in electronic circuits. JFETs are characterized by using a single carrier type in N-channel or P-channel configurations, where the channel is surrounded by PN junctions. These junctions are central to the device's ability to control current flow.
In an N-channel JFET, the structure consists of N-type material forming the channel on a P-type substrate, with the gate...

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by
Same author

Cyclic sealing and drainage on an oceanic transform fault.

Science (New York, N.Y.)·2026
Same author

Xiaoyao San attenuates postmenopausal atherosclerosis via ERα-mediated suppression of hepatic PCSK9 transcription.

Phytomedicine : international journal of phytotherapy and phytopharmacology·2026
Same author

Development and Validation of an ELISA Method for Quantification of HuB01 in Fermentation Products.

Biotechnology and applied biochemistry·2026
Same author

Genome-wide CRISPR knockout screening identifies novel disease-associated genes in retinal pigment epithelium cells.

Experimental eye research·2026
Same author

Lipid Tail Length Determines Nano-Bio Interactions of Peptide Amphiphile Nanostructures.

Small (Weinheim an der Bergstrasse, Germany)·2026
Same author

A beam model and Boltzmann solver for radiotherapy treatment planning of superficial brain metastases using a scanned electron beam at ultra-high (FLASH) dose rate.

Physics in medicine and biology·2026

Related Experiment Video

Updated: Jul 10, 2026

Laser-induced Forward Transfer for Flip-chip Packaging of Single Dies
08:21

Laser-induced Forward Transfer for Flip-chip Packaging of Single Dies

Published on: March 20, 2015

All-optical flip-flop based on vertical cavity semiconductor optical amplifiers.

Deqiang Song1, Veronica Gauss, Haijiang Zhang

  • 1Electrical and Computer Engineering Department, University of California, San Diego, 9500 Gilman Drive, La Jolla, California 92093, USA.

Optics Letters
|October 17, 2007
PubMed
Summary

Researchers developed an all-optical set-reset (SR) flip-flop using vertical cavity semiconductor optical amplifiers (VCSOAs). This compact, low-power device enables optical signal processing for future integrated photonic circuits.

More Related Videos

Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators
09:23

Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators

Published on: May 30, 2014

Related Experiment Videos

Last Updated: Jul 10, 2026

Laser-induced Forward Transfer for Flip-chip Packaging of Single Dies
08:21

Laser-induced Forward Transfer for Flip-chip Packaging of Single Dies

Published on: March 20, 2015

Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators
09:23

Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators

Published on: May 30, 2014

Area of Science:

  • Photonics
  • Optical Computing
  • Semiconductor Devices

Background:

  • All-optical signal processing is crucial for high-speed computing.
  • Existing optical flip-flops often require high switching power or are not easily integrated.
  • Vertical Cavity Semiconductor Optical Amplifiers (VCSOAs) offer potential for compact and efficient optical devices.

Purpose of the Study:

  • To demonstrate the operation of a novel all-optical set-reset (SR) flip-flop.
  • To investigate the performance of VCSOAs in creating flip-flop functionality.
  • To explore the potential for integrated all-optical memory and timing circuits.

Main Methods:

  • Utilized two cross-coupled electrically pumped VCSOA inverters.
  • Leveraged cross-gain modulation, polarization gain anisotropy, and nonlinear gain characteristics.
  • Designed and operated an all-optical SR flip-flop circuit.

Main Results:

  • Achieved successful operation of the all-optical SR flip-flop.
  • Demonstrated low optical switching power of approximately 10 microwatts.
  • Showcased potential for integration on a small footprint of around 100 square micrometers.

Conclusions:

  • The developed VCSOA-based all-optical SR flip-flop is cascadable and efficient.
  • This technology paves the way for on-chip all-optical fast memories.
  • Enables new possibilities for all-optical timing regeneration circuits.