Related Experiment Video
Updated: Jul 10, 2026

Mouse Lumbar Vertebra Uniaxial Compression Testing with Embedding of the Loading Surface
Published on: December 1, 2023
Load sharing within a human thoracic vertebral body: an in vitro biomechanical study
Cumhur Kilinçer1, Serkan Inceoğlu, Moon Jun Sohn
1Department of Neurosurgery, Trakya University Medical Faculty, Edirne, Turkey. ckilincer@trakya.edu.tr
Objective:
The vertebral body is the major load bearing part of the vertebra and consists of a central trabecular core surrounded by a thin cortical shell. The aim of this in vitro biomechanical study is to determine the debated issue of load sharing in a vertebral body.
Methods:
A series of non-destructive compressive testing on excised human thoracic vertebral bodies were performed. The testing process consisted of a stepwise removal of the vertebrae's trabecular centrum and measurement of surface strains.
Results:
Load sharing of cortical shell of osteopenic vertebrae (48.1+/-7.6) was significantly higher than that of normal vertebrae (44.3+/-10.6). Load sharing of middle thoracic vertebrae (49.4+/-10.0) was significantly higher than that of lower thoracic vertebrae (42.4+/-8.5). According to general linear model analysis, test speed and load were not found to be effectual on load sharing with the exception that osteopenic vertebrae showed lower cortical load sharing under higher loads.
Conclusions:
The cortical shell takes nearly 45% of physiological loads acting upon an isolated thoracic vertebra. Load sharing between cortical shell and trabecular centrum is significantly affected by spinal level and bone mineral density. The load borne by trabecular bone increases towards the lower spinal levels, and decreases by osteoporosis.
Related Concept Videos
Normal Strain under Axial Loading
General Case of Eccentric Axial Loading
Consider a member subjected to equal and opposite forces that are applied along a line that does not coincide with the member's neutral axis. In unsymmetrical bending,...
Pressure Relationships in Thoracic Cavity
Breathing Mechanisms
Both intra-alveolar and intrapleural pressures rely on specific lung properties. The ability to breathe—allowing air to enter the lungs during...
Structural Joints: Cartilaginous Joints
There are two types of cartilaginous joints:
Synchondrosis
A synchondrosis ("joined by cartilage") is a cartilaginous joint where bones are connected by hyaline cartilage. Synchondrosis may be temporary or...