Related Experiment Video
Updated: Jul 10, 2026

Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
Radiological significance of cement used in building construction in Turkey
1Sarayköy Nuclear Research and Training Center, Istanbul Road 30 km., Saray, Ankara, Turkey.
Abstract:
The activity concentration of (226)Ra, (232)Th and (40)K in seven cement types from different factories and grinding plants were measured using a gamma ray spectrometry with HPGe detector. The average activity concentrations observed in the studied cement samples (all from 141 samples) were 40.0 +/- 27.1, 28.0 +/- 20.9 and 248.3 +/- 95.0 Bq kg(-1) for (226)Ra, (232)Th and (40)K, respectively. The radium equivalent activity (Ra(eq)), the representative level index, the indoor absorbed dose rate and the corresponding annual effective dose were estimated for the potential radiological hazard of the cement. The Ra(eq) values were compared with the corresponding values for cement of different countries. The mean indoor absorbed dose rate (87.4 +/- 48.5 nGy h(-1)) is slightly higher than the population-weighted average of 84 nGy h(-1), whereas the corresponding effective dose rate (0.4 +/- 0.2 mSv y(-1)) is lower than the dose criterion of 1 mSv y(-1). The obtained results indicate no significant radiological hazards arise from using Turkish cement in building construction.
Related Concept Videos
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in ASTM C...
Aggregate Cement Ratio
Types of Cement II
Soundness of Cement
Strength and Heat of Hydration
The heat of hydration for each cement compound is significant; for instance, tricalcium aluminate (C3A) and...

