Related Experiment Video
Updated: Jul 10, 2026

Hemi-laryngeal Setup for Studying Vocal Fold Vibration in Three Dimensions
Published on: November 25, 2017
Estimation of impact stress using an aeroelastic model of voice production
Jaromír Horácek1, Anne-Maria Laukkanen, Petr Sidlof
1Institute of Thermomechanics, Academy of Sciences of the Czech Republic, Prague, Czech Republic. jaromirh@it.cas.cz
Abstract:
The maximum impact stress at the contact of the vocal folds achieved during the oscillation cycle was estimated in phonation using an aeroelastic model of voice production. Relations of impact stress to the lung pressure, fundamental frequency of self-oscillations, prephonatory glottal width, sound pressure level generated at the end of the glottis and vibration amplitude of the vocal folds were studied. Using the fundamental frequency, prephonatory glottal width, lung pressure and airflow rate values found in normal speech, maximum impact stress values of 2-3 kPa were obtained. The results fall well within the limits reported for excised canine larynges and human subjects. Impact stress increased with lung pressure almost linearly after the phonation threshold but reached a plateau when the limit of maximum glottal opening was reached. When the fundamental frequency and lung pressure were kept constant, impact stress appears to fit closely with a parabolic function of prephonatory glottal half-width.
Related Concept Videos
Impact Loading
In cases of elastic deformation,...
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Applications of Stress
The...
Stress on an Oblique Plane
Transformation of Plane Stress
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...

