Related Experiment Video
Updated: Jul 10, 2026

Synthesis of Cyclic Polymers and Characterization of Their Diffusive Motion in the Melt State at the Single Molecule Level
Published on: September 26, 2016
(19)F-(19)F and (19)F-(1)H spin-spin coupling constants in cyclic FH polymers (FH)(n), n=2-6
Janet E Del Bene1, José Elguero
1Department of Chemistry, Youngstown State University, Youngstown, OH 44555, USA. jedelbene@ysu.edu
Abstract:
Spin-spin coupling constants (2h)J(F-F), (1)J(F-H), and (1h)J(H-F) have been obtained for cyclic complexes (FH)(n), with n=2-6, from ab initio equation-of-motion coupled cluster singles and doubles (EOM-CCSD) calculations. Although both the Fermi-contact (FC) term and (2h)J(F-F) increase and become positive as the cluster size increases, the FC term is not a good quantitative approximation to (2h)J(F-F). The paramagnetic spin-orbit (PSO) and spin-dipole (SD) terms which contribute to (2h)J(F-F) appear to be sensitive to the orientation of the hydrogen-bonded pair. However, the large increase in the FC term and (2h)J(F-F) as the size of the cluster increases is due primarily to the reorganization of sigma electron densities in both ground and excited states, and is another manifestation of cooperativity effects in hydrogen-bonded cyclic polymers. The FC term and (1)J(F-H) always increase upon complex formation, but (1)J(F-H) increases only slightly as the size of the cluster increases due to a concurrent decrease in the PSO term. The changes in (1)J(F-H) as a function of polymer size reflect the polarization of electron density away from H and toward F in the ground state, and the electron reorganization which occurs in the excited states which couple to the ground states through the FC and PSO operators. The FC term is a good approximation to (1h)J(H-F), and is always negative, indicating that the hydrogen bonds in the FH clusters are traditional hydrogen bonds.
More Related Videos
09:43Interfacial Molecular-level Structures of Polymers and Biomacromolecules Revealed via Sum Frequency Generation Vibrational Spectroscopy
Published on: August 13, 2019
08:17Practical Aspects of Sample Preparation and Setup of 1H R1ρ Relaxation Dispersion Experiments of RNA
Published on: July 9, 2021
Related Concept Videos
Spin–Spin Coupling: Three-Bond Coupling (Vicinal Coupling)
The extent of coupling depends on the C‑C bond length, the two H‑C‑C angles, any electron-withdrawing substituents, and the dihedral angle between the involved orbitals. The...
Spin–Spin Coupling: One-Bond Coupling
Spin–Spin Coupling: Two-Bond Coupling (Geminal Coupling)
The central atom need not be NMR-active because its electrons are affected by the electron polarization of the spin-active atoms. However, spin information is transmitted less effectively than in one-bond coupling, and 2J values are usually weaker than 1J values. The energy of...
Spin–Spin Coupling Constant: Overview
Qualitatively, any spin plus-half nucleus polarizes the spins of its electrons to the minus-half state. Consequently, the paired electron in the hydrogen–carbon bond must have a...
¹H NMR: Long-Range Coupling
In alkenes, spin information is communicated via σ–π overlap, as seen in allylic (four-bond) and homoallylic (five-bond) couplings. These coupling interactions are stronger when the σ bond is parallel to the alkene π orbitals.
¹H NMR: Interpreting Distorted and Overlapping Signals
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are slanted or...