Related Experiment Video
Updated: Jul 9, 2026

Speciation and Bioavailability Measurements of Environmental Plutonium Using Diffusion in Thin Films
Published on: November 9, 2015
Influence of sources on plutonium mobility and oxidation state transformations in vadose zone sediments
Daniel I Kaplan1, Brian A Powell, Martine C Duff
1Savannah River National Laboratory, Aiken, South Carolina 29808, USA. daniel.kaplan@srs.gov
Abstract:
Well-defined solid sources of Pu(III) (PuCl3), Pu(IV) (Pu (NO3)4 and Pu (C2O4)2), and Pu(VI) (Pu02(NO3)2) were placed in lysimeters containing vadose zone sediments and exposed to natural weather conditions for 2 or 11 years. The objective of this study was to measure the release rate of Pu and the changes in the Pu oxidation states from these Pu sources with the intent to develop a reactive transport model source-term. Pu(III) and Pu(IV) sources had identical Pu concentration depth profiles and similar Pu release rates. Source release data indicate that PuIV(C2O4)2 was the least mobile, whereas Pu(VI)O2(NO3)2 was the most mobile. Synchrotron X-ray fluorescence (SXRF) revealed that Pu was very unevenly distributed on the sediment and Mn concentrations were too low (630 mg kg(-1)) and perhaps of the wrong mineralogy to influence Pu distribution. The high stability of sorbed Pu(IV) is proposed to be due to the formation of a stable hydrolyzed Pu(IV) surface species. Plutonium X-ray absorption near-edge spectroscopy (XANES) analysis conducted on sediment recovered at the end of the studyfrom the Pu(IV)(NO3)4- and Pu(III)(III)Cl3-amended lysimeters contained essentially identical Pu distributions: approximately 37% Pu(III), 67% Pu(IV), 0% Pu(V), and 0% Pu(VI). These results were similar to those using a wet chemistry Pu oxidation state assay, except the latter method did not detect any Pu(III) present on the sediment but instead indicated that 93-98% of the Pu existed as Pu(IV). This discrepancy was likely attributable to incomplete extraction of sediment Pu(III) by the wet chemistry method. Although Pu has been known to exist in the +3 oxidation state under microbially induced reducing conditions for decades, to our knowledge, this is the first observation of steady-state Pu(III) in association with natural sediments. On the basis of thermodynamic considerations, Pu(III) has a wide potential distribution, especially in acidic environments, and as such may warrant further investigation.
More Related Videos
06:52Experimental Column Setup for Studying Anaerobic Biogeochemical Interactions Between Iron (Oxy)Hydroxides, Trace Elements, and Bacteria
Published on: December 19, 2017
11:43Dissolved Solute Sampling Across an Oxic-Anoxic Soil-Water Interface Using Microdialysis Profilers
Published on: March 24, 2023
Related Concept Videos
Microbial Bioremediation of Uranium
Voltammetry: Stripping Methods
Anodic Stripping Voltammetry (ASV)
ASV is used to determine metals and metalloids at trace levels. It involves two steps: deposition and stripping. First, a negative potential is applied to the...
Voltammetry: Factors Affecting Measurements
Acid Mine Drainage
Microbes and Other Elemental Cycles
Ladder Diagrams: Redox Equilibria
Consider the Fe3+/Fe2+ half-reaction, which has a standard-state potential of +0.771 V. At potentials more positive than +0.771 V, Fe3+ predominates, whereas Fe2+...