Related Experiment Video
Updated: Jul 9, 2026

Composition and Distribution Analysis of Bioaerosols Under Different Environmental Conditions
Published on: January 7, 2019
Determination of O(3), NO (2), SO (2), CO and PM (10) measured in Belgrade urban area
Dragan M Marković1, Dragan A Marković, Anka Jovanović
1Institute of Physics, Pregrevica 118, POB 68, 11080 Belgrade, Serbia.
Abstract:
O(3), NO(2), SO(2), CO and PM(10) concentrations, simultaneously determined for the first time in Belgrade urban area in the autumnal period of 2005, are presented. The obtained results display similar behaviour of SO(2), NO(2), CO, PM(10) opposite from that of O(3). The weekend effect was also investigated showing diminution of average daily concentrations of SO(2), NO(2), PM(10) and CO for 72, 40, 37 and 42% respectively, and increase of the average daily concentration of O(3) for 56%. Influence of meteorological conditions on observed concentration levels was studied, too. The observed influence of wind speed on the O(3) nightly concentration levels was analyzed pointing to the phenomena of O(3) transport during episodic measurements. To make an identification of possible pollution sources and analyse the influence of meteorological parameters on pollution levels, air back trajectories for high level concentrations episodes were calculated and analysed. A multivariate receptor modelling (Principal Component Analysis, Cluster Analysis) has been applied to a set of data in order to determine the contribution of different sources. It was found that the main principal components, extracted from the air pollution data, were related to gasoline combustion, oil combustion and ozone transport.
More Related Videos
07:14Automated, High-resolution Mobile Collection System for the Nitrogen Isotopic Analysis of NOx
Published on: December 20, 2016
09:33Visualizing Field Data Collection Procedures of Exposure and Biomarker Assessments for the Household Air Pollution Intervention Network Trial in India
Published on: December 23, 2022
Related Concept Videos
Measurement of Air Content in Concrete
The pressure method,...
Specific Gravity of Aggregate
Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...
Gravimetry: Overview
In precipitation gravimetry, the analyte is converted into a precipitate and weighed. For example, the silver content in a sample can be estimated by precipitating and...
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...