Related Experiment Video
Updated: Jul 9, 2026

Preparation of Food Samples Using Homogenization and Microwave-Assisted Wet Acid Digestion for Multi-Element Determination with ICP-MS
Published on: December 22, 2023
Simultaneous determination of vitamin B12 and its derivatives using some of multivariate calibration 1 (MVC1)
Abdolraouf Samadi-Maybodi1, S K Hassani Nejad Darzi
1Analytical Division, Faculty of Chemistry, University of Mazandaran, Babolsar, Iran. samadi@umz.ac.ir
Abstract:
Resolution of binary mixtures of vitamin B12, methylcobalamin and B12 coenzyme with minimum sample pre-treatment and without analyte separation has been successfully achieved by methods of partial least squares algorithm with one dependent variable (PLS1), orthogonal signal correction/partial least squares (OSC/PLS), principal component regression (PCR) and hybrid linear analysis (HLA). Data of analysis were obtained from UV-vis spectra. The UV-vis spectra of the vitamin B12, methylcobalamin and B12 coenzyme were recorded in the same spectral conditions. The method of central composite design was used in the ranges of 10-80 mg L(-1) for vitamin B12 and methylcobalamin and 20-130 mg L(-1) for B12 coenzyme. The models refinement procedure and validation were performed by cross-validation. The minimum root mean square error of prediction (RMSEP) was 2.26 mg L(-1) for vitamin B12 with PLS1, 1.33 mg L(-1) for methylcobalamin with OSC/PLS and 3.24 mg L(-1) for B12 coenzyme with HLA techniques. Figures of merit such as selectivity, sensitivity, analytical sensitivity and LOD were determined for three compounds. The procedure was successfully applied to simultaneous determination of three compounds in synthetic mixtures and in a pharmaceutical formulation.
Related Concept Videos
Measurement of Bioavailability: Pharmacodynamic Methods
Determination of Multiple Dosing Parameters: Steady-State, Minimum and Maximum Concentrations
Measurement of Bioavailability: Pharmacokinetic Methods
Calibration Curves: Linear Least Squares
For data that follow a straight line, the standard method for fitting is the linear...
