Related Experiment Video
Updated: Jul 7, 2026

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters
Published on: February 4, 2018
Optimal and suboptimal design of SAW bandpass filters using the Remez exchange algorithm
1Dept. of Semicond. Phys., Byelorussian State Univ., Minsk.
Abstract:
Optimal and suboptimal design techniques for surface acoustic wave (SAW) linear phase filters based on both the Remez exchange algorithm and the McClellan computer program (J.H. McClellan et al., 1973) are considered. The optimal synthesis provides uniquely the best fit to a design target, but its major drawback is an excessive amount of computation. The suboptimal synthesis technique proposed allows a considerable reduction of the amount of computations without significantly sacrificing the approximation accuracy. Thus computer runtime and storage are greatly reduced compared to the optimal synthesis. The detailed suboptimal theory and some practical design aspects are discussed. Design examples are presented which confirm the efficiency and the flexibility of the synthesis techniques proposed.
Related Concept Videos
Bandpass Sampling
A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2. The spectrum...
Active Filters
Passive Filters
Low-Pass Filters
Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff frequency...
Design Example
Upsampling
Parallel Resonance
